RAYOMOVIL GO Mobile Phone User Manual

: September 15, 2024
: RAYOMOVIL

Table of Contents

RAYOMOVIL GO Mobile Phone
Introduction
Input Methods
Phone Book
Settings
Usage and treatment of battery
Maintenance and service
FCC Caution
Read User Manual Online (PDF format)
Download This Manual (PDF format)

RAYOMOVIL GO Mobile Phone

Declaration
Please read the user’s manual to keep your mobile phone in the best condition. The manual has been verified and reviewed to guarantee the accuracy. Instructions and descriptions contained herein are accurate at the time of publication. However, mobile phones developed afterward, and the contents of their manual are subject to modification without further notification. Our company reserves the rights in relation to the manual.

Introduction

Password
Phone password
With the prone password, vou can prevent others Trom using your mobile phone without your approval. Ine orpinal Mione password Is 1234.
Insert the sim card and the battery
Ensure to turn off the equipment and disconnect with the charger before taking out the battery.
Startup and shutdown
Press the key of power supply to start up or shut down the mobile phone. If it is prompted to input PIN or UPIN, please input the required password (shown as **** on the screen).
Antenna
Your mobile phone may be provided with a built-in and exposed antenna. Just like using any other radio and transmitting devices, don’t touch the antenna if not necessary because it may affect the quality of telecommunication and result in equipment operating in an energy level higher than required, thus shortening the service life of the battery.

Input Methods

Need to be sure to change one of Input Methods.

Phone Book

You may save the information of contacts including names & telephone numbers in the phone book. The storable entries of sim card depend on the type of the card.

Settings

General
Security setting You may set functions in relation to cell phone security. (phone lock: 1234)|
Restore the factory
settings Enter the correct password of the phone will have to change your phone settings back to factory default state value, the user of the function be used with caution. (Default password: 1234).
Phone
Network setting
The option is related to your network provider. Please get in contact with the network provider for that. Flight Mode: No communication function is available in-flight model.
Flight Mode: No communication function is available in-flight model.
Switch mode
You may select modes of dual-standby and single-pass, SIM 1 on/SIM 2on and flight mode.
WAP
You may surt online with WAP brower, which means that you may surt online at any time and in any place. For details, please Rel in contact with the nearest network service provider.
Video recorder
In the options of the video camera, you may set the exposure compensation, avoidance of flickering, white balance, special effects, profile etc.
Camera
In the nations of camera you may set the photometry made etc. You may enter the album.
Audio Player
The music player is used to play music files in supported formats in the current player’s list.
Video player/Image Viewer
Check the video or pictures files supported by the cell phone.
File manager
For the memory card, you may establish a data file folder etc.
Call history
The call list lists all types of calls, including missed ones, dialed ones and answered ones, or you may enter the separate lists of missed calls, dialed calls and answered calls for check or adoration’
FM Radio
Turn on/FM broadcast, and you may manually tune the channel.
Recorder
Use this function you can record or listen to your own record.
Connection
Edit and set the GPRS access point Note: The “account data” is to be provided by the network operator.
Alarm
Set the time of alarm clock. At the time of alarm clock, an alarm ring will be given as Der the cutting.
Bluetooth
Technology You may establish wireless connection with other compatible devices with Bluetooth.
Pe connect
Mass storage
Use the T-Flash inserted in the mobile phone as U-Disk.
Lamp
Support Lamp function.
Calendar
Support Calendar function.
Calculator
Support Calculator function.
SOS
Support SOS function.
Original Accessories
Refer to the local dealer for supply of accessories. Hereafter are some precautions for usage of the accessories:

1. Please keep the accessories out of the children’s reach. Hold the plug and pull out instead of pulling the power cord when the power supply. Regularly check the mobile equipment in the automobile to see whether they are correctly installed and whether work normally.
2. Only use batteries, chargers and accessories approved by the manufacturer.
3. Usage of other types of batteries, chargers and accessories may result in violence of the certification or warranty terms or even lead to danger.

Why is required to use the original accessories
Battery and charger are key parts of a mobile part because they play important roles in guaranteeing te normal operation of the mobile phone as well as your satety. lots shown in our long-term customer investigation and aftersales service that lots of mobile phone failures results.
Hazards resulting from usage of ineligible hatters and charges.

  1. Shorten the battery service le with times of battery charting discharging much lower than that or the original battery.
  2. Shorten the service life of the mobile phone largely. The unstable voltage will affect the normal operation of the circuit, resulting in permanent damage
  3.  Affects the performance and reliability of the mobile phone, reducing the voice quality and being Meowielp Mateusten.
  4. May result in burning or explosion and thus endanger the personal safety of the customers.

About the battery
Charging and discharging
A chargeable battery is used for the equipment. One battery may be charged and discharged ron several nunoreas of times and minally will be disabled. In case the standard time and call duration snoren obviously, pledse replace me battery, the battery is replaced and used for the tirst time, or the battery nas been neot tor a long time before using, It may be necessary to connect with the charger, disconnect and then reconnect in order to charge the battery. When the charger is not used, please disconnect with the equipment and olue it out through the coweri socket It the battery runs out of electricity, you may have to wait tor a tew minutes till the symbol of charging is shown on we screen, and then you can make and answer any call. Don’t use the battery for any other purpose. Don’t use any damaged charger or battery

Usage and treatment of battery

Avoid short circuit of the battery; otherwise, the battery may be damaged, and generate heat to cause fire hazards;
Don’t put the battery under high temperatures or in fire; otherwise, it may explode;

Don’t attempt to take apart the battery;

Stop usage in case of damage or obvious aging of battery and charger;
Return waste and used batteries to the supplier or specified recovery site.
Don’t throw it away in domestic garbage.

Maintenance and service

Your equipment is a product with exquisite design and process. Please use it carefully.
Following are some suggestions for you to effectively use the maintenance service.

Keep the equipment dry. Rainwater, moisture, other liquids or moisture contents may contain mineral matters, which may erode the electronic wires. If the equipment is wetted, please take out of the battery till the equipment is totally dried and then put in the battery.
Don’t use or store the equipment in dusty or filthy places; otherwise, the detachable parts and electronic elements may be damaged.
Don’t put the equipment in overheated places.
Don’t keep the equipment in under cooled places; otherwise, when the temperature rises to normal, moisture may be generated within the equipment, resulting in damage of the circuit board.
Please open the equipment as per the descriptions in the manual. Don’t try any other means.
Don’t throw, knock or shake the equipment. Any rough treatment of the equipment may result in damage of the inner circuit board and its exquisite structure.
Don’t clean the equipment with ardent chemical, detergent or strong wash.
Don’t paint any dyestuff on the equipment.
Painting may block foreign substances in detached parts and thus affect normal operation. Clean the lens with clean, dry soft cloth (such as the camera lens, range sensor and light sensor).
Only use matched or approved antenna for the substation of the damaged one. Unapproved antenna, alteration or accessories may result in damage of the equipment and violence of relevant specifications on radio equipment. Please use the charger in indoor area.
Back-up data that should be kept (such as the address directory and calendar memorandum).
Please turn off the equipment and take out the battery to restore the equipment setting irregular to maintain optimal performance.
The above suggestions also apply to your equipment, battery, charger and other accessories.
In case any device doesn’t work, please take it to the nearest authorized maintenance agency for repair.

FCC Caution

Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions

this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation. Specific Absorption Rate (SAR) information:

This mobile phone meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue.

Device types: Portable Equipment (FCC ID: 2AEJARAYOGO) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the head is 0.58 W/kg and when properly worn on the body is 0.83 W/kg. This device was tested for typical body-worn operations with the back of the handset kept 10mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 10mm separation distance between the user’s body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that does not satisfy these requirements may not comply with FCC RF exposure requirements and should be avoided.

Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 10mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or approved antenna.