IKEA TRADFRI 30 W LED Driver for Wireless Control Instruction Manual

September 12, 2024
Ikea

IKEA TRADFRI 30 W LED Driver for Wireless Control

IKEA-TRADFRI-30-W-LED-Driver-for-Wireless-Control-
PRODUCT

Specifications

  • Type: ICPSLC24-30NA-IL-2
  • Input: 100-120 VAC, 50/60Hz, 0.39 A
  • Output: 24.0 VDC
  • Max total load : 1.25 A, 30.0 W
  • Radio range: 10 m in open air
  • Operating frequency: 2405-2480 MHz
  • Output power (EIRP): 8 dBm
  • Indoor use only
  • Manufacturer: IKEA of Sweden AB

USING INSTRUCTION

If you have the TRÅDFRI gateway or DIRIGERA hub Go to App Store or Google Play and download the IKEA Home smart app. The app will take you through the process of installing your product and other devices.

How to steer your lighting

  • When the product is connected to the mains, it is possible to turn it ON/OFF with the main switch or the foot switch, but if you want to dim or connect your product to other IKEA Home smart products, you need to buy a separate steering device (e.g. a remote control).
  • The steering device needs to be paired with your wireless product. If you have more than one (1) wireless product, you can pair each one with the steering device so that the entire combination can be turned ON/OFF or dimmed at the same time.

Pairing a steering device to your product

  1. Connect at least one (1) product to the mains before you begin the pairing. Make sure that the mains power is turned ON.
  2. Locate the pairing symbol on the LED driver. Hold the steering device close to the pairing symbol (no more than 5 cm away).
  3. Press and hold the pairing button on the steering device for at least 10 seconds. A red LED light will shine steadily on the steering device. The product will begin to dim and flash one time to indicate that it has being paired to the steering device.

How to factory reset your driver
If the product does not respond or if you want to un-pair the product from a steering device, you might have to perform a factory reset. The unit is forced to factory reset by carefully pushing and holding in the small button (marked RESET) with a tip of pen on the LED driver enclosure and applying slight pressure.

IMPORTANT!

  • The product is for indoor use only and can be used in temperatures ranging from 5 °C to 45 °C.
  • Do not leave the product in direct sunlight or near any heat source, as it may overheat.
  • The declared radio range between the unit and the steering device is measured in open air.
  • Different building materials and placement of the units can affect the wireless connectivity range.

Care instructions

To clean the unit, wipe with a dry soft cloth.
Never use abrasive cleaners or chemical solvents as this can damage the product.

PRODUCT SERVICING

Do not attempt to repair this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks.
Save these instructions for future use.

Technical data:

  • Type: ICPSLC24-30NA-IL-2
  • Input: 100-120 VAC, 50/60Hz, 0.39 A
  • Output: 24.0 VDC
  • Max total load : 1.25 A, 30.0 W
  • Radio range: 10 m in open air. Operating
  • frequency: 2405-2480 MHz
  • Output power (EIRP): 8 dBm Indoor use only
  • Manufacturer: IKEA of Sweden AB
  • Address: Box 702, SE-343 81 Älmhult, SWEDEN

This device complies with Part 15 of the FCC Rules.
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation Science and Economic Development Canada’s license-exempt RSS standard(s).

Operation is subject to the following two conditions:

  1. this device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation of the device.

WARNING:
Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

RF EXPOSURE INFORMATION
According to RF exposure regulations, under normal operations the end user shall refrain from being closer than 20 cm from the device.

License rights and limitations

  • NO RIGHTS OR LICENSES, EXPRESS
  • NO RIGHTS OR LICENSES, EXPRESS
  • OR IMPLIED, ARE GRANTED TO USE THIRD-PARTY DEVICES IN COMBINATION WITH THESE PRODUCTS IN A WIRELESS MESH NETWORK, OR TO USE THIRD-PARTY SERVICES TO ACCESS, MONITOR OR CONTROL THESE PRODUCTS IN
  • A WIRELESS MESH NEWORK VIA THE INTERNET OR ANOTHER EXTERNAL WIDE AREA NETWORK.

For use pursuant to U.S. Patent Nos.:

  • US 6,914,893
  • US 7,697,492
  • US 8,964,708

The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.

© Inter IKEA Systems B.V. 2022

FAQ

  • Q: Can I use third-party devices with this product?
    • A: No, using third-party devices in combination with these products in a wireless mesh network is not permitted.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals