tunnu CC1 Multifunctional Camping Light User Manual
- August 27, 2024
- tunnu
Table of Contents
tunnu CC1 Multifunctional Camping Light
Product Information
Specifications
- Flood Lumen Light Runtime: 800Lm for 4 hours, 400Lm for 8 hours, 50Lm for 20 hours
- Spot Lumen Light Runtime: 600Lm, 200Lm, 50Lm for 4 hours, 8 hours, 20 hours respectively
- Capacity: 3.6V/3000 mAh
- IP Grade: IP65 (Except for the remote control)
- Weight: 588g
- Size: 50*470mm
- Max Height: 1920mm
- Drop Rated: 1m
- Remote Control Distance: 5m
Product Usage Instructions
Status Description
- Operating mode: Light on means the product is operating, including flood mode, spot mode, and strobe mode, controllable by remote.
- Standby mode: Light off means stand by with power indicator on. Remote control supported.
- Shutdown mode: Light off. Remote control not supported.
Operating Guidance
- Button: Click to open, again to switch between low, mid, high, stand by, low cycle. Long press for 1.5 sec to shutdown.
- Double click: Switch between spot and flood mode. Long press for 3 sec changes to blinking pattern in any mode. Click to switch strobe to SOS mode. Long press or double click for exit.
- Mode Switch: Click to follow low – mid – high – low mode cycle (only for floodlight mode).
Battery Indicator
- Green light on: 50% – 100% capacity
- Red light on: 15% – 50% capacity
- Red light flash: Caution, 0% – 15% capacity
- Red light flash while charging: Charging in progress
- Green light on while charging: Charging completed
Warning
The product emits high brightness; do not look directly at the light to avoid
vision loss. Keep out of reach of children. Do not throw the product into fire
due to the battery present.
Frequently Asked Questions (FAQ)
-
Q: Can the remote control be used in all modes?
A: The remote control can only control the floodlight mode when powered on or in standby. -
Q: Is there a mode memory function in the product?
A: Yes, the product has a mode memory function. It will return to the last used mode upon powering on. -
Q: What should I do if the battery capacity is low?
A: If the battery capacity is low (15% or less), it is recommended to recharge the product to avoid power outage during use.
Parameter
| High | Med | Low | |
|---|---|---|---|
| FLliogohdt | Lumen | 800Lm | 400Lm |
| Runtime | 4H | 8H | 20H |
| Lsipgohtt | Lumen | 600Lm | 200Lm |
| Runtime | 4H | 8H | 20H |
| Capacity | 3.6V/ 3000 mAh | ||
| IP Grade | IP 65（Except for the remote control） | ||
| Weight Size | 588g | ||
| Max Height | φ50*470mm | ||
| Drop Rated | 1920mm | ||
| Remote Control | 1 m | ||
| Di tance | ＞5m |
*The above data were tested in the laboratory environment, and the actual date will change with the different use environments.
Status Description
- Operating mode: light on means operating. Including flood mode, spot mode and strobe mode which can be controlled by remote.
- Stand-by mode: light off means stand by and power indicator on. Support remote control.
- Shutdown mode: light off. Remote control is not supported.
Function Interface
- Hook
- Spotlight
- Flood light
- Button
- Type-C port
- Indicator
- Magnet
- Remote control
- Light switch
- Mode switch
Operating Guidance
- Button
- Click to open, and again to switch. Follow low →mid →high→stand by→low cycle.
- Double-click to switch spot and flood mode.
- Long press for 1.5 sec to shut down.
- Long press for 3 sec change to a blinking pattern in any mode. Click to switch the strobe to SOS mode. Long press or double click for exit.
- Light Switch
- Click to cycle power on and off mode(only for floodlight mode)
- Mode Switch
- Click to follow low -mid -high -low mode cycle(only for floodlight mode)
*When in spot mode or blinking mode, click any button will switch floodlight first and then to control on/off and mode.
*The remote control can only control floodlight mode when powered on or stand by.
*These products have mode memory function. So when its on, it will go back to the mode that you turn off last time.
Power indicator
SAFETY WARNINGS
caution
- Read the instructions carefully before use
- After 30 minutes will automatically be turned off with no operation when in standby mode.
- Only support spot mode with 30Lm when charging.
- Please replace the battery of the remote control in time.
- When you click the remote control but the indicator light in the upper left corner is not on.
- When changing the remote control button battery, please put the positive upward.
- In order to guarantee the performance of this product, if long time not used, please make sure that every 3 months to charge one time.
Warning
- The product have high brightness, do not look straight into the light, lest cause vision loss.
- Keep this product out of the reach of children.
- This product contains a battery, so it is forbidden to be thrown into the fire, to avoid danger such as explosion accidents.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>