Labrador IM-01252024 Table Light Instruction Manual
- August 8, 2024
- Labrador
Table of Contents
Labrador IM-01252024 Table Light Instruction Manual
Safety Warnings
These instructions are for your safety. Please read through them thoroughly
before use and retain them for future reference. If you are in any doubt about
installing this product, consult a qualified electrician.
This product is only suitable for connection to a 220-240V-50Hz supply. It is
for indoor use only, and not suitable for a bathroom location.
This fitting is a Class II, Double Insulated product and does not require an
Earth. Live or Neutral must not be connected to Earth.
Do not attempt to plug in or use this product until it has been fully
assembled. Disconnect from mains during assembly or maintenance, this product
must be used on a stable, flat surface.
Under no circumstances must this lamp be covered with any material as this
could pose a safety hazard. This product is not a toy and not suitable for
persons under 14 years of age.
This product may contain delicate parts – be careful during handling and
maintenance to avoid breakage.
The lamp must be protected by a 3 amp fuse in the mains plug.
Never fit bulbs of a higher wattage than those specified on the label as these
may damage the fitting. Never put anything on the product or hang anything on
any part of this product.
If the external flexible cable or cord of this luminaire is damaged, it must
only be replaced by a qualified electrician to avoid any electrical hazards.
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist Check with your Local Authority or local
store for recycling advice.
Care and maintenance
For bulb replacement, switch off the product and allow it to cool down
(Caution: bulb gets hot during use).
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this
product.
Troubleshooting
When the bulb does not light after installation:
- Please plug in and operate the switch to turn your lamp on.
- Please check the bulb.
- Please check the 3 amp fuse in the plug and ultimately check the relevant fuse in your fuse box.
If you have any doubt about installation/use of this product, consult a qualified electrician. To use this item in Europe, the 3 pin adaptor can be removed by loosening the central screw and removing the adaptor to reveal the 2 pin Europe plug.
Converting 3 pin to 2 pin plug
Scan QR code for multi-language
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG, Brilliantstrasse 1, D-27442 Gnarrenburg
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>