Mingqin ES-H180 Series Pan Tilt Selfie Stick User Manual
- July 31, 2024
- Mingqin
Table of Contents
Mingqin ES-H180 Series Pan Tilt Selfie Stick
Operating Instructions
The remote control is detachable
Pull out the phone clip to install the phone
Raise the handle to unlock the pan-tilt head
Cell phone clip with 360° rotation
Telescopic poles can be stretched on demand
Open the tripod from the bottom
Bluetooth Remote Control
- Tap Settings> Bluetooth on your phone and turn your phone’s Bluetooth on.
- Toggle the power switch upwards to turn on the remote control.
- When your phone searches for a Bluetooth device named “Selfie’~ tap it and select pairing.
- Turn on the camera function on your phone and press the photo button to take a photo or video recording.
- Toggle the power switch down to turn off the phone.
Video Tutorials
Scan the code for a video tutorial
Fill Light
* The fill Light is optional, please refer to the configuration of the purchased products
-
Power button : click to turn on the light, click again to switch the light mode until power off; long press the power button to adjust the brightness of the light.
-
Charging: Use the USB SV adapter to connect to the charging port for charging.
-
Power button : click to turn on the light, click again to switch the light mode until power off; long press the power button to adjust the brightness of the light.
-
Charging: Use the USB SV adapter to connect to the charging port for charging.
Extended Interface
This product comes with an extendable threaded connector.
Align the device with the extended interface and screw it into the connector,
at this time, pay attention to leave a proper gap, and then tighten the knob
upward to complete the connection.
Warm reminder: the bearing capacity of the head is limited, please do not install too heavy equipment to avoid damage.
Fault Resolution
-
Bluetooth remote control can not be turned on.
»> Charge the remote control and retry after charging. -
Bluetooth cannot be connected/fails to work properly after power on.
»> Remove the bluetooth pairing on your phone, restart the bluetooth remote control and re-pair the connection. -
If Android phone can’t take photos with the remote control
-
»> Press the photo button to adjust the volume:
Open Camera App, change “Volume Function” to default or take photo, then you can take photo with remote control. -
»> Press the photo button can not adjust the volume:
Follow the steps in question 2 to re-pair and connect.
Reminders
- Do not store the product in a low-temperature, humid environment.
- Do not expose the product to high temperatures such as sunlight or fire.
- Do not use the product in places where the equipment is restricted to avoid violating public order.
- This product contains small parts, please keep it out of the reach of infants and young children to prevent them from swallowing it accidentally.
- The pictures and dimensions shown in the package and manual are for reference only, please refer to the actual product.
FCC COMPLIANCE STATEMENT:
This device complies With part 15 of the FCC Rules’ Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received , including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and , if
not installed and used in accordance with the instructions, may cause harmful
interference to radio.
Communications
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on , the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help
Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’ s authority to operate the equipment
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement The device can be used in portable exposure condition without restriction.