VILLAON V8001 8 Inch 32 GB Pink User Manual

VILLAON V8001 8 Inch 32 GB Pink

Hereby, ORAIMO MOBILE LIMITED declares that this Tablet is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.

Know your Tablet

1. Front camer
2. Speaker
3. Audio Jack
4. SD card Slot
5. Type C
6. Volume – key
7. Power key
8. Volume + key
9. MIC
10. Rear Camera
11. RESET Hole
    

SD Card Installation

1. Power off tablet.
2. Refer to the following picture for SD card installation
   

Charging The Tablet

You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the tablet).

Use only VILLAON charger and cables. Other chargers or cables may damage the device. This will invalidate your tablet warranty.

WARRANTY CONDITIONS

The warranty period starts at the time of product’s original purchase by the first end-user. The product may consist of several different parts and different parts may be covered by a different warranty.

What is not covered?

1. This Limited Warranty does not cover user manuals or any third party software, settings, content, data or links included or downloaded in the product, whether included during installment, assembly, shipping or any other time in the delivery chain or otherwise and in any way acquired by you. We cannot warrant that any software will meet your requirements, will work in combination with any hardware or software provided by a third party, that the operation of any software will be uninterrupted or error free or that any defects in the software are correctable or will be corrected.

2. This Limited Warranty does not cover.
   (a) Normal wear and tear (including, without limitation, wear and tear of camera lenses, batteries, or displays)
   (b) Defects caused by rough handing (including, without limitation, defects caused by sharp objects, by bending, compressing or dropping, etc.).
   (c) Defects or damage caused by misuse of the Product, including use that is contrary to the instructions provided (e.g. as set out in the Product’s user guide).
   (d) Transport costs.
   (e) Other acts beyond the reasonable control.

3. This Limited Warranty does not cover defects or alleged defects caused by the fact that the product was used with, or connected to, any product, accessory, software or service not manufactured, or supplied by our company, or was used otherwise than for its intended use. Defects can be caused by viruses from your or a third party’s unauthorized access to services, other accounts, computer systems or networks. This unauthorized access can take place through hacking, password mining or through a variety of other means.

4. This Limited Warranty does not cover defects caused by the fact that the battery has been short-circuited or by the fact that the seals of the battery enclosure or the cells are broken or show evidence of tampering or by the fact that the battery has been used in equipment other than those for which it has been specified.

5. This Limited Warranty is not enforceable if the Product is opened, modified or repaired by anyone other than an authorized service center, if it is repaired using unauthorized spare parts or if the product’s serial number, the tablet accessory date code or the IMEI number has been removed, erased, defaced, altered or are illegible in any way and this shall be determined in the sole discretion of us.

6. This Limited Warranty is not enforceable if the Product has been exposed to moisture, to dampness or to extreme thermal or environmental conditions or to rapid changes in such conditions, to corrosion, to oxidation, to spillage of food or liquid or to influence from chemical products.

Frequency Range(RF):

Bluetooth: 2400-2483.5 MHz (TX/RX);
Wi-Fi: 2400-2483.5 MHz (TX/RX);

Max. Of Transmit power:

BT(EDR): 12.83dBm
BLE:9.25dBm
WiFi:15.66dBm

Specific Absorption Rate (SAR) Certification

THIS DEVICE MEETS INTERNATIONAL GUIDELINES FOR EXPOSURE TO RADIO WAVES

CAUTION：

1. Risk of explosion if battery is replaced by an incorrect type, dispose of used batteries according to the instructions.
   • disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
   • leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;
   • a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
2. EUT Temperature: 0℃~ +50℃(Standalone). 0℃~+40℃(with adapter).
3. Adapter:U050VEA
   Input:100-240V~50/60Hz, 0.2A
   Output:5V 1A 5W,MAX

 High sound pressure with hearing damage risk. Do not listen at high volume levels for long periods.

Operating System: Android TM（Go edition） Android is a trademark of Google LLC.

EU DECLARATION OF CONFORMITY in accordance with

Annex VI of Directive 2014/53/EU of the European Parliament and of the Council

1. For the following Radio equipment:
   Model:V8001
   Product: Tablet
   Trade name or Brand: VILLAON Software / Hardware number: V8001-A133/V1.0

2. Name and address of the manufacturer or his authorized representative: Manufacturer: ORAIMO MOBILE LIMITED Add: FLAT Q, 8/F., INTERNATIONAL INDUSTRIAL CENTRE, NOS. 2-8 KWEI TEI STREET, SHATIN NT

3. This declaration of conformity is issued under the sole responsibility of the Manufacturer.

4. Object of the declaration (identification of the radio equipment allowing traceability; it may include a colour image of sufficient clarity where necessary for the identification of the radio equipment):

5. The object of the declaration described above is in conformity with the relevant Union harmonization legislation: Directive 2014/53/EU (RED)

6. References to the relevant harmonised standards used or references to the other technical specifications in relation to which conformity is declared:
   1a Health:
   EN 50566:2017
   EN 62479:2010
   EN 62209-2:2010+A1:2019
   a Safety:
   EN62368-1:2014+A11:2017
   EN IEC 62368-1:2020+A11:2020
   Article 3.1b:
   ETSI EN 301 489-1 V2.2.3 (2019-11)
   ETSI EN 301 489-17 V3.2.4 (2020-09)
   EN 55032:2015+A11:2020+A1:2020
   EN 55035:2017+A11:2020
   EN IEC 61000-3-2:2019+A1:2021
   EN 61000-3-3:2013+A1:2019+A2:2021
   Radio

7. Notified   Body Name: Eurofins Electrical and Electronic Testing NA, Inc.
   Notified Body Number: 0980
   Notified Body Assessment Performed: Module B/C on Article 3.1a, 3.1b, 3.2 Technical File Identification Number: N/A

8. Where applicable, description of accessories and components, including software, which allow the radio equipment to operate as intended and covered by the EU declaration of conformity: User instructions are provided in the User Manual. The Software and Hardware versions are specified above.

9. Additional information:
   Referring to Article 10.2 of the Directive, this equipment is so constructed that it can be operated in all Member States, without infringing applicable requirements on the use of radio spectrum.
   Referring to Article 10.10 of the Directive, there are no restrictions on putting this equipment into service or of requirements for authorization of use.
   Please refer to the User Manual for details. On behalf of:
   Manufacturer: ORAIMO MOBILE LIMITED Add: FLAT Q, 8/F., INTERNATIONAL INDUSTRIAL CENTRE, NOS. 2-8 KWEI TEI STREET, SHATIN NT (place and date of issue): Shenzhen, 2023-10-17 (name, function): Nengyong.Wu / Manager

(signature):
(Name and signature of person responsible)

FCC CAUTION

changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:

FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types:V8001(FCC ID: 2AXYP-V8001) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification properly worn the body is 1.005 W/kg. This device was tested for typical body-worn operations with the back of the handset kept 0mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 0 mm separation distance between the user’s body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly.

The use of accessories that does not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided.

Body-worn Operation

This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 0mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>