645 H-308FB 2 Lever Versi Upholstered Operator Chair Installation Guide

Table of Contents

Important – Please read these instructions fully before starting assembly.
Check you have all the components and tools listed.
Remove all fittings from the plastic bags and separate them into their groups.
Keep children and animals away from the work area, small parts could choke if swallowed.
Make sure you have enough space to lay out the parts before starting.
Do not stand or put weight on the product during assembly, this could cause damage.
Assemble the item as close to its final position (in the same room) as possible.
Assemble on a soft level surface to avoid damaging the unit or your floor.
Parts of the assembly will be easier with 2 people.
We do not recommend the use of power drill/drivers for inserting screws, as this could damage the unit.
Only use hand screwdrivers.
Dispose of all packaging carefully and responsibly.

Only clean using a damp cloth and mild detergent, do not use bleach or abrasive cleaners.
From time to time check that there are no loose screws on this unit.
Do not stand on the chair.
Do not use this chair as a step ladder.
This product should not be discarded with household waste. Take it to your local authority waste disposal center.

Handy Hints

Assemble all parts and bolts loosely during assembly, only once the product is complete should you fully tighten the bolts.
Regularly check and ensure that all bolts and fittings are tightened properly.

Please check you have all the parts listed below

Components – Fittings

Step1 Fitting the base Push all five castors 6 into the underside of the base 5.
Insert the gas lift 4 into the base 5. Put the gaslift cover 7 onto the gaslift 4
Step 2 Fitting the Backrest
Put the plastic cover into the seat plate 2
Put the backrest and insert the seat plate 3
Step 3 Finishing the Unit Install the knob back to the seat plate
Step 4 Carefully locate the seat onto the base unit 2

Read User Manual Online (PDF format)