Darkglass Electronic Alpha Omicron Core Series User Manual

July 11, 2024
Darkglass Electronic

Darkglass Electronics Alpha Omicron Core Series

Specs

Controls

  • Blend: Mixes the clean and processed signals. The clean signal remains at unity gain while the volume of the overdriven signal is set by the Level knob, allowing for fine mix tuning.
  • Level: Sets the volume of the overdriven signal.
  • Drive: Sets the amount of gain in the overdriven signal.
  • Mod: Selects or mixes between the two distinct distortion circuits: Alpha is punchy, and tight with a lot of definition, whereas Omega is simply brutal and raw.
  • Bite: Boosts High Mids (2.8kHz) for additional presence and definition.
  • Growl: Shelving Bass Boost for a fatter tone and increased low-end saturation.

Technical Specifications

  • Input Impedance : 1kΩ
  • Output Impedance : 1kΩ
  • Current Consumption : ~11mA
  • Voltage : 9V DC (Center Negative)

Dimensions

  • Width : 75 mm / 2,95″
  • Length : 111 mm/ 4,37″
  • Height : 43 mm / 1,69″
  • Weight : 250 g / 0,55 lb

Warning
The Alpha·Omicron has a current draw of 20mA. Only use a regulated 9V DC adapter with a center-negative plug. Unregulated power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding the warranty.

Warranty

To activate the warranty, we encourage you to register your product at: http://mypedal.darkglass.com and enter the serial number on the back of your pedal. Please contact us via email at support@darkglass.com before shipping a product to us.

Disclaimer
In the interest of continuous improvement, specifications are subject to change without notice. If you have any questions, please don’t hesitate to contact us atwww.darkglass.com The manufacturer claims that the above product fulfills the requirements as set by EN55013, EN55020, EN60555-2, EN60555-3, RoHS, WEEE. 1176®, and SSL® are registered trademarks of their respective companies. Names of factory modes are intended for descriptive purposes only and should not be construed as an endorsement or affiliation with the companies or products named.

FCC STATEMENT

EMC / EMI

This equipment has been tested and found to comply with the limits for a Class B Digital device, under part 15 ofthe FCC rules. These limits are designed to protect reasonably against harmful interference in residential installations.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation.
Suppose this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. In that case, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

DARK GLASS is a registered trademark in the U.S., number 4,616,801, owned by Darkglass Electronics Oy. Designed by Revolve Studio

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals