Allied Green Venture 0000001 Fans Energy Saver Ceiling Fan User Manual

User Manual

BLDC Ceiling Fan

ALLIED GREEN VENTURE

BLDC Ceiling Fans

Parts of a Ceiling Fan

1. Nut
2. Clamp
3. Top Canopy
4. Safety Wire
5. Screw
6. Down rod
7. Bottom Canopy
8. Fan Shaft
9. Fan Blade
10. Ceiling Fan
11. Fan wires
12. Terminal Box
13. Shaft Bolt

Steps of installation

Step 1:
Remove the nuts and bolts from the motor shaft to insert the down rod.

Step 2:
Insert the down rod over the shaft of the fan, aligning the holes of the shaft and the down rod to insert bolts and safety screw. Once aligned and bolts were inserted, tighten the bolt and safety screw. On the opposite side insert the pin and bend both the ends.

1. Down rod
2. Bolt and nut
3. Insert pin in the hole of bolt
4. Aligning the holes

Step 3:
Connect the fan terminals to one end of the terminal box and connect a set of two wires to the other end of the terminal box and pass them through the inside of down rod from the lower hole to the top hole of the down rod. Also pass the safety wire in the same way as that of the wires.

Step 4:
Insert the top and bottom canopy on rod. Adjust the bottom canopy so that there is sufficient gap between the bottom canopy and the ceiling fan.

1. Pair of wires connected to other end of the terminal
2. Wires of the fan

Step 5:
Place the separator between the blade and the fan and then screw all the 3 blades on the fan one by one with nuts and washers.

1. Bolts
2. Holes

Step 6:
Make sure power supply is switched off. Now place the rubber shackle on the ceiling hook. Now lift the fan and align the holes of the clamp and down rod. Once aligned, insert the bolt and washer and tighten it with nut. Insert the split pin in the hole and bend the ends.

1. Safety wire
2. Ceiling hook
3. Fixing clamp with down rod using bolts

Step 7:
Ensure safety wire is correctly fitted and securely tightened with the ceiling hook.

Step 8:
Connect the wires of the fan with the power supply and taped with insulated tape properly.

Step 9:
Adjust the top canopy to cover the wire connections. Maintain suNicient gap between bottom canopy and the fan.

Remote Function

1. Power ON/OFF
2. LED ON/OFF
3. Speed control 1 to 6
4. Boost
5. Timer ON/OFF
6. Reverse action
7. Set time for 2/4/8 Hrs

Points to be noted.

• Fan must be installed at the center of the room.
• There should be at least 30cm of distance between the ceiling wall and the fan.
• Sufficient distance must be there between the walls of the room and the fan.
• Vertical height from the fan motor to the floor must be more than 7ft.
• Fan must be installed and by a trained electrician/professional.
• While cleaning the fan, A/C supply must be switched off.
• All the electrical connections must be insulated with insulation tape.
• Safety wire must be installed as per the instructions.
• Nuts, bolts must be tightened properly.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>