Tommee Tippee Single Bottle Steriliser Instructions Manual
- June 8, 2024
- Tommee Tippee
Table of Contents
single bottle steriliser
INSTRUCTIONS FOR USE
MICROWAVE STEAM STERILISATION
This sterilizer is designed for use with closer to nature bottles. For instructions on cleaning and sterilizing Tommee Tippee closer to nature bottles please refer overleaf.
5 Allow cooling for 3 minutes before removing the sterilizer from the microwave.
7 Wash your hands thoroughly before handling sterilized items. Take care as
the items will be hot.
8 Remove the basket (rotate basket lid anti-clockwise to remove) and lift out
sterilised items. Makeup feed according to manufacturer’s instructions.
9 If the steriliser is left unopened bottle will remain sterile for 3 hours.
After this time re-sterilisation is required.
WARNING
Always add 80ml of water before use. Ensure the unit does not boil dry. Ensure
the microwave is set correctly on full power. Always allow 3 minutes of
cooling time before removing it from the microwave. When removing the
steriliser from the microwave, take care, as the unit will contain hot water
and steam. Place on a hard, heat resistant surface. Always release steam
using the steam vent before completely removing the lid. Do not use chemical
sterilising solutions/tablets in the microwave. If you have a combination
oven, ensure the grill is switched off and the oven has cooled before use.
Always follow loading instructions to ensure sterilisation. Do not place
metallic items in the microwave as damage could result. Make sure the
microwave turntable is clean and dry before use. If components are washed in a
dishwasher with other items, which have residues of strong coloured sauces
(e.g. tomato), they may discolour over time. Keep out of reach of small
children.
COLD WATER STERILISATION
- Prepare a sterilising solution as instructed by the sterilising solution manufacturer. You will need approximately 1.5 L.
- Place closer to nature bottle upright inside the basket and place the basket inside the steriliser.
- Ensure the bottle is filled first, then continue to fill the Steriliser until the solution reaches the base of the neck.
- Place hood upside down inside the bottleneck ensuring that it is completely submerged.
- Place assembled screw cap and teat upside down inside the hood ensuring that it is completely submerged.
- Assemble the basket lid to the basket with the twist lock feature ensuring that all the bottle components are fully submerged in the Sterilising solution.
- Assemble the Steriliser lid to the Steriliser ensuring the pouring/steam vent is in the closed position.
THE UNIT IS NOT WATERTIGHT AND THEREFORE MUST REMAIN IN THE UPRIGHT POSITION.
bottle & teats
FOR YOUR CHILD’S SAFETY & HEALTH
WARNING
Always use this product with adult supervision. Before first use clean the
product. Never use feeding teats as a soother. Continuous and prolonged
sucking of fluids will cause tooth decay.
Always check food temperature before feeding. Inspect before each use and pull
the feeding teat in all directions. Throw away at the first signs of damage or
weakness.
Do not leave the feeding teat in direct sunlight or near a source of heat, or
leave it in disinfectant (“sterilising solution”) for longer than recommended,
as this may weaken the teat. Before first use, place in boiling water for 5
minutes. This is to ensure hygiene. Clean before each use. Always wash the
product immediately after use. Accidents have occurred when babies have been
left alone with drinking equipment due to the baby falling or if the product
has disassembled. Tooth decay in young children can occur even when non-
sweetened fluids are used. This can occur if the baby is allowed to use the
bottle for long periods through the day & particularly through the night, when
saliva flow is reduced or if it is used as a soother.
For safety and hygiene reasons it is recommended the teat is replaced at least
every 2 months. Keep all components not in use out of reach of children.
not cleaned thoroughly after each use
Ensure the valve is flushed with warm water during cleaning.
DO NOT turn the teat inside out for cleaning. Damage could result.
Use a teat brush, but not on the anti-colic valve (see above*).
DO NOT clean or allow to come into contact with solvents or harsh chemicals.
Do not store in direct sunlight or near a source of heat. Damage could result.
DO NOT allow the product to come into contact with oil-based foods (e.g.
oil/tomato based sauces) as staining will occur.
CLEANING & STERILISING
The new Tommee Tippee teat and screw ring have been designed to be placed into the sterilizer fully assembled, in order to avoid assembly problems after sterilization
Alternatively, after use, the components can be disassembled, washed, and sterilized as normal. Suitable for all forms of sterilization.
MAKING UP FEEDS
Makeup feeds according to the feed manufacturer’s instructions. Use cooled
freshly boiled water. DO NOT use hot water. Heating in a microwave oven may
produce localized high temperatures. Take extra care when microwave heating.
Always stir heated food to ensure even heat distribution and test the
temperature before serving. Do not heat in a microwave with a bottle sealed.
Remove teat, locking ring, and dome cap.
Not suitable for use in a conventional oven or a combination microwave oven
with the grill feature switched on.
Mayborn Baby and Child
Northumberland Business Park West
Cramlington, Northumberland NE23 7RH, UK
Mayborn Baby and Child
is a trading style of Jackel International Limited.
Copyright© Jackel International Limited 2008
tommeetippee.com
Tommee Tippee Single Bottle Steriliser Instructions Manual – Download
[optimized]
Tommee Tippee Single Bottle Steriliser Instructions Manual –
Download
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>