Tommee Tippee Express and Go Pouch and Bottle Warmer Instructions Manual
- June 8, 2024
- Tommee Tippee
Table of Contents
express and Go
Pouch and Bottle Warmer
INSTRUCTIONS FOR USE
- Replace water after every use
- Do not open lid whilst red light is on and unit is in operation
- If mains power is disconnected unit will reset
- Unit does not maintain temperature of feed
- Unit will not allow you to change the selection whilst in operation
- Do not store a bottle or pouch in the unit
Information on the disposal for Waste Electrical & Electronic Equipment (WEEE)
This symbol on the products and accompanying documents means that used
electrical and electronic products should not be mixed with general household
waste. For proper disposal for treatment, recovery and recycling, please take
these products to designated collection points where they will be accepted on
a free of charge basis. In some countries you may be able to return your
products to your local retailer upon the purchase of a new product. Disposing
of this product correctly will help you save valuable resources and prevent
any possible effects on human health and the environment, which could
otherwise arise from inappropriate waste handling. Please contact your local
authority for further details of your nearest collection point for WEEE.
Penalties may be applicable for the incorrect disposal of this product in
accordance with national legislation. The product is fitted with a BS 1363
mains plug containing a 13A fuse. If it ever becomes necessary to replace the
fuse, only use fuses that are marked BS 1362, and rated at 13A. In the
unlikely event that this plug is not suitable for the sockets in your home, it
should be removed and a suitable plug fitted as follows: The wires of the
mains lead are coloured in accordance with the following code: GREEN AND
YELLOW – EARTH BLUE – NEUTRAL BROWN – LIVE As these colours may not correspond
with the coloured markings sometimes used to identify the terminals in the
plug, connect as follows. The wire coloured GREEN AND YELLOW must be connected
to the terminal marked E or by the earth symbol or coloured GREEN or GREEN AND
YELLOW. The wire coloured BLUE must be connected to the terminal marked N or
coloured BLACK. The wire coloured BROWN must be connected to the terminal
marked L or coloured RED. If you are in any doubt about how to wire a plug or
replace a fuse safely, consult a qualified electrician.
Jackel International Limited trading as Mayborn Group Northumberland Business
Park West
Cramlington
Northumberland
NE23 7RH, UK
Leaflet Number: 0422147
Please read and retain this important information for future reference.
Copyright © Jackel International Limited 2015
Model Number: 1118
Voltage: 220-240V ~ 50/60Hz 500W
This product complies with European Low Voltage Directive
2014/35/EU and EMC Directive 2014/30/EU
Jackel International Limited retains all intellectual property rights to this
product and packaging, including all two and three dimensional designs,
graphic images, logos and text. Any unauthorised manufacture, publication,
reproduction, communication or adaptation of any materials comprised in this
product or its packaging is strictly prohibited and may constitute
infringement of relevant laws. Jackel International Limited is incorporated in
England and Wales under company number 01894022. TOMMEE TIPPEE and CLOSER TO
NATURE are registered trademarks of Jackel International Limited.
Any questions?
Visit our website www.tommeetippee.com
or call us FREE on 0500 97 98 99 (UK only)
tommeetippee.com
IMPORTANT WARNINGS
KEEP THIS INSTRUCTION SHEET FOR FUTURE REFERENCE AS IT INCLUDES IMPORTANT
INFORMATION.
Please ensure that you read these instructions thoroughly and use the
appliance in accordance with instructions strictly. Please note misuse may
lead to injury. Do not immerse in water.
This appliance can be used by children aged from 14 years and above if they
have been given supervision or instruction concerning the use of the appliance
in a safe way and understand the hazards involved. Cleaning and user
maintenance shall not be made by children unless they are aged 14 yearsand
above and supervised. Keep the appliance and its cord out of reach of children
aged less than 3 years. Appliances can be used by persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children shall
not play with this appliance. Ensure that the heating guidelines are followed
to ensure that the food is not heated for too long. For your child’s safety –
Always check food temperature before feeding by testing on a sensitive part of
your skin. This appliance is intended for household use only. Do not use
outdoors. User maintenance other than cleaning and descaling is not required
for this product. Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions or has been damaged in any manner. If the
supply cord is damaged, it must be changed by a qualified person in order to
avoid a hazard. If the damage is from new, the unit must be returned to the
manufacturer. If within a retail warranty period and proof of purchase
retained; this product should be exchanged at place of purchase. The
manufacturer will then be made aware. Any questions? Visit our website
www.tommeetippee.com or call us FREE on 0500 97 98 99 (UK only)
SETUP
Please refer to instructions leaflet before use and remember to clean and descale your unit regularly
Fill base unit with 250ml/9floz water
If heating a pouch, insert pouch holder – bottles can be placed directly in to
the base of the unit
Plug unit in to mains power supply and place the unit on a clean, dry kitchen
work surface
Hold down the power button for 2 seconds to turn on the unit. The LED will
flash red and beep once to show the the unit is in standby mode
The unit is now ready to use
USAGE
For your childs safety always check food temperature before feeding by testing
on a sensitive part of the skin
To turn on the unit – hold down the power button for 2 seconds, the LED will
flash red and beep once to show that the unit is in standby mode
Select temperature – press until the green LED is adjacent to your requirement
Select pouch or bottle type – press until the green LED is adjacent to your
requirement
Select volume of feed – press until the green LED is adjacent to your
requirement
Insert feed – we recommend using the pouch holder to support all milk storage
pouches, Bottles can be placed directly in to the base of the unit. For
hygiene we recommend leaving the hood on the teat
Close the lid
Press the power button – LED will turn solid red and beep once to show the
cycle has started
When cycle finishes the unit will beep 3 times and red light will start to flash. Unit will automatically turn off when cycle is complete and reset
Open lid and remove feed taking care not to touch the water inside the unit as it will have heated during the cycle. Empty unit and replace water after every use to ensure it holds the correct amount
To cancel a cycle – hold down the power button and the temperature selection button for 5 seconds and unit will reset
CLEANING & DESCALING
The descaling process will remove deposits of calcium and other minerals in
the system that may affect its performance
CLEANING
After each use, unplug and allow to cool before cleaning. Pour away any excess
water and wipe with a damp cloth only. Do not clean with abrasive cleaners or
allow to come in to contact with solvents or harsh chemicals, damage could
result.
DESCALING
We recommend carrying out the descaling process approximately every 4-weeks.
If you notice limescale earlier than 4-weeks, descaling may be required
sooner. Living in a hard water area can produce limescale quicker than other
areas. You can find out your water quality via your water provider. You may
need to repeat either process if you find that limescale is still present.
Alternatively, you may wish to use a specific descaling solution suitable for
electric warmers if your build up is significant, you may need to use a
stronger solution.There are two methods of descaling that you can follow for
your warmer.
Option 1:
1. Empty the electric warmer and wipe down the inside with a clean sponge or
damp cloth.
2. Pour in 250ml of white vinegar.
3. Leave for at least 30 minutes, or up to 24-hours depending on the extent
of the limescale.
4. Pour any remaining liquid down the sink. Rinse the interior of the warmer
well with cool water and use a clean sponge or damp cloth to remove any build
up that came loose as a result of the descaling/cleaning process.
5. Plug unit back in and add regular amounts of water you use for normal
warming. Turn on and run for 5 minutes to remove any additional build up. Upon
completion, rinse warmer again and use as directed.
Option 2:
1. Empty the electric warmer and wipe down the inside with a clean sponge or
damp cloth.
2. Pour in 250ml of white vinegar.
3. Turn on the warmer and run for a cycle, approximately 5-minutes.
4. Unplug the unit and leave to cool, then pour any remaining liquid down the
sink. Rinse the interior of the warmer well, with cold water and use a clean
or damp cloth to remove any build up that came loose as a result of the
descaling/cleaning process.
5. Plug unit back in and add regular amounts of water you use for normal
warming. Turn on and run for 5 minutes to remove any additional build up. Upon
completion, rinse warmer again and use as directed.
Jackel International Limited trading
as Mayborn Group
Northumberland Business Park West
Cramlington
Northumberland
NE23 7RH, UK
Copyright © Jackel International Limited 2015.
TOMMEE TIPPEE is a registered trademark
of Jackel International Limited.
Tommee Tippee Express and Go Pouch and Bottle Warmer Instructions Manual –
Download [optimized]
Tommee Tippee Express and Go Pouch and Bottle Warmer Instructions Manual –
Download
0300000-bottle-and-teat-leaflet
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>