Tommee Tippee Bottle and Teat Information Manual

Product Information for: Bottle and Test

For best results Make Sure this valve can open
www.tommeetippee.cn

WARNINGS

FOR YOUR CHILDS SAFETY & HEALTH

WARNING!
✓ Always use this product with adult supervision. Accidents have occurred when babies have been left alone with drinking equipment due to the baby falling or if the product has been disassembled.
✓ Always check food temperatures before feeding. Heating in a microwave oven may produce localised high temperatures.Take extra care when microwave heating.
✓ Always stir heated food to ensure even heat distribution and test the temperature before serving.
✓ When making up a feed, follow the formula milk manufacturer’s instructions and allow the freshly boiled water to cool before pouring it into the bottle.
✓ Glass Bottle may break if dropped
✓ Glass Bottle may break.

X Never use feeding teats as a soother.
X Continuous and prolonged sucking of fluids will cause tooth decay. Tooth decay in young children can occur even when non-sweetened fluids are used. This can occur if the baby is allowed to use the bottle for long periods through the day and particularly through the night, when saliva flow is reduced or if it is used as a soother.

PRODUCT ASSEMBLY

QUICKSTART:

1.  Before use, wash all parts in warm soapy water, rinse in clean water and sterilise.
2. Assemble your bottle as per the above diagram.
3. When assembling your bottle it is important that you check the valve (C) by holding it to the light to check that the slit in the silicone has not sealed closed. If it has sealed closed, pinch it gently between your fingers to re-open. If the valve has sealed closed your bottle will not vent properly.
4. Make up your feed.
5. Serve.
6. After use wash all parts in warm soapy water, rinse in clean water, ready to sterilise once more.

CLEANING & STERILISING

✓ Before first use, clean the product.
✓ Always wash the product immediately after use.
✓ Clean before each use.
✓ Before first use place in boiling water for 5 minutes. This is to ensure hygiene.
✓ Wash in warm soapy water and rinse in clean water or use a dish washer (top shelf only).
✓ For cleaning other bottle parts, use a closer to nature teat & spout brush.
✓ Once you have cleaned your bottles they are ready to sterilise.
✓ All bottle components should be sterilised.
✓ All bottle components are suitable for sterilisation by steam (electric or microwave), boiling or cold water tablet / liquid sterilization.

X   Do not clean with harsh chemicals.
X   Do not allow product to come into contact with oil-based foods (e.g. oil /tomato based sauces) as staining will occur.
X   Do not turn the teat inside out for cleaning. Damage could result.
X   Do not use a teat brush or any other implement to clean the feeding hole in the end of the teat or valve as damage such as splits and tears may occur.

✓ TAKE EXTRA CARE when cleaning the easi-venty” valve. In order to ensure optimum venting, the teat valve is manufactured using a thinner silicone than the teat itself and therefore care needs to be taken during cleaning to ensure no damage is caused.
X   DO NOT USE A TEAT BRUSH or any other implement to clean the easi- vent”” valve/the feeding hole as damage such as splits and tears may occur. However, performance of the teat may be affected if the easi-vent”” valve is not cleaned thoroughly after each use. Ensure valve is flushed with warm water during cleaning.

STORAGE & USE

✓ Inspect before each use and pull the feeding teat in all directions. Throw away at the first signs of damage or weakness.
✓ Keep all components not in use out of reach of children.
✓ For safety and hygiene reasons it is recommended that the feeding teat is replaced every 2 months.

X Do not store or leave in direct sunlight or near a source of heat or leave in disinfectant (“Sterilising Solution”) for longer than recommended, as this may weaken the teat.
X   Do not store with or allow to come into contact with solvents or harsh chemicals.
X   Not suitable for use in a conventional oven or a combination microwave oven with the grill feature switched on.
X   Do not heat in a microwave with bottle sealed. Remove teat, locking ring, and dome cap.

Jackel International Limited trading as Mayborn Group. Copyright° Jackel International Limited 2016

Jacket International Limited retains all intellectual property rights to this product, packaging, and printed or electronic media, including all two and three-dimensional designs, graphic images, logos and text. Any manufacture, publication, copying, hiring, lending and reproduction of any materials is strictly prohibited and constitutes infringement.

TOMMEE TIPPEE and CLOSER TO NATURE are registered trademarks of Jacket International Limited.
EAST-VENT is a trademark of Jacket International Limited.
Protected by China patent numbers 200580049380.7 and 200580022130.4
M3,401-s (Leaflet No.): 0300000

Tommee Tippee Bottle and Teat Information Manual – Download [optimized]
Tommee Tippee Bottle and Teat Information Manual – Download

042210-uk-bottle–teat-leaflet_web-pdf

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>