JB HiFi DAXYS Street Helmet Instruction Manual
- June 3, 2024
- JB HiFi
Table of Contents
JB HiFi DAXYS Street Helmet
Important instructions for the use and care of your new bicycle helmet.
Thank you for choosing our helmet. Please take a moment to read the following information to ensure that you get the best out of your new helmet and that you wear your helmet safely. We designed this helmet to give you maximum comfort and ventilation with excellent protection in the event of a cycling accident
INSTRUCTIONS FOR SAFE USE AND CARE
- Helmet for paved, recreational use by pedal cyclists.
- WARNING: This bicycle helmet is not intended to be used in Motor Sports or by Motor Cyclists.
- No helmet can protect the wearer against all possible impacts.
- The helmet is designed to be retained by a strap under the lower jaw.
- To be effective, a helmet must fit and be worn correctly. To check for the correct fit, place the helmet on the head and make any adjustments indicated. Securely fasten retention system. Grasp the helmet and try to rotate it to the front and rear. A correctly fitted helmet should be comfortable and should not move forward to obscure vision or rearward to expose the forehead.
- No attachments should be made to the helmet except those recommended by the helmet manufacturer.
- The helmet is designed to absorb shock by partial destruction of the shell and liner. This damage may not be visible.
- Therefore, if subjected to a severe blow, the helmet should be destroyed and replaced even if it appears undamaged.
- The helmet may be damaged and rendered ineffective by petroleum and petroleum products, cleaning agents, paints, adhesives, and the like, without the damage being visible to the user.
- A helmet has a limited lifespan in use and should be replaced when it shows obvious signs of wear.
- This helmet sh or doing other activities where there is a risk of hanging or strangulation if the child gets trapped while wearing the helmet. not d by children while climbing EU
- WARNING: Before cycling, ensure the helmet straps are properly fastened. Never use the helmet with the buckle in an open position. If the helmet is not fitted and fastened Correctly, the helmet cannot provide the level of protection it has been designed for.
CLEANING
To clean this helmet, you should only use some soft soap and water. The helmet may be damaged and rendered ineffective by petroleum products, cleaning agents, paints, adhesives, and the like, without the damage being visible to the user. Do not use the helmet if it has been exposed to any substances different from water and soap.
INSTRUCTIONS FOR SIZING AND FITTING HELMET
Fit the helmet by adjusting the fitting system to suit. If it doesn’t fit
comfortably try a smaller or larger size. Snap buckle halves together and pull
down on the loose ends of the strap to tighten, or place your thumb under the
buckle and lift it out from your jaw to loosen the strap. Adjust the straps
through the side wedges so that they sit just below your ears and there is
even tension on the front and rear straps.
Distributed by: Pammi Pty Ltd 174 Broadway, Chippendale, NSW, 2008, Australia
- CERTIFIED PRODUCT
- Australian & NZ Standard
- AS/NZS 2063:2008+A1:2009
- BMP 754251
Documents / Resources
| JB
HiFi DAXYS Street
Helmet
[pdf] Instruction Manual
Street Helmet, DAXYS Street Helmet, DAXYS Helmet, DAXYS, Helmet
---|---