evolur AURORA CRIB Installation Guide

AURORA CRIAURORA CRIB

ASSEMBLY INSTRUCTIONS
The model shown is an example only. Styles may vary

ASSEMBLY INSTRUCTIONS-Instructions pour l’assemblage

Adult assembly required.
Small parts may present choking hazards prior to assembly.
Enclosed please and simple step-by-step instructions to help you quickly assemble your product. Before you begin, we recommend that you follow the steps below:
1. Please read the instructions thoroughly
2. Identify all parts and hardware
3. You may need to provide the following tools:

• Philips Head screwdriver
• Flathead screwdriver
• Hammer

Do Not Use Power Drills Or Drivers
To protect your parts during assembly please please place them on a soft surface. To clean the surface, use only water on a damp cloth.
Do not use window cleaner or cleaning abrasive as it will scratch the surface and could damage the protective coating.

WARNING!
Should this product become damaged, and/or components are broken or missing, DO NOT USE

LIMITED WARRANTY

• Evolur warrants its product to be free from defects in material and workmanship and agrees to remedy any such defect.
• This warranty covers 1 year from the date of original purchase.
• This warranty is valid only upon presentation of proof of purchase.
• This is solely limited to the repair or replacement of defective furniture components and no assembly labor is included.
• This warranty does not apply to any product which has been improperly assembled, subjected to misuse or abuse of which has been altered or repaired in any way.
• This warranty gives you specific legal rights and you may also have other rights which vary from State to State.

WARNING!

• FAILURE TO FOLLOW THESE WARNINGS AND ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
• TO REDUCE THE RISK OF SIDS, PEDIATRICIANS RECOMMEND HEALTHY INFANTS BE PLACED ON THEIR BACKS TO SLEEP, UNLESS OTHERWISE  ADVISED BY YOUR PHYSICIAN
• CHECK THIS PRODUCT FOR DAMAGED HARDWARE, LOOSE JOINTS, MISSING PARTS, OR SHARP EDGES BEFORE AND AFTER ASSEMBLY AND FREQUENTLY DURING USE.
• DO NOT USE THIS CRIB IF ANY PARTS ARE MISSING, DAMAGED, OR BROKEN. CONTACT
• DO NOT USE A WATER MATTRESS WITH THIS CRIB.
• READ ALL INSTRUCTIONS BEFORE ASSEMBLING THE CRIB. KEEP INSTRUCTIONS FOR FUTURE USE.
• IF REFINISHING, USE A NON-TOXIC FINISH SPECIFIED FOR CHILDREN’S PRODUCTS. STRANGULATION HAZARD:
• STRINGS CAUSE STRANGULATION! DO NOT PLACE ITEMS WITH A STRING AROUND A CHILD’S NECK, SUCH AS HOOD STRINGS OR PACIFIER CORDS. DO NOT SUSPEND STRINGS OVER A CRIB OR ATTACH STRINGS TO TOYS.
• TO HELP PREVENT STRANGULATION TIGHTEN ALL FASTENERS. A CHILD CAN TRAP PARTS OF BODY OR CLOTHING ON LOOSE FASTENERS.
• DO NOT PLACE CRIB NEAR WINDOW WHERE CORDS FROM BLINDS OR DRAPES MAY STRANGLE A CHILD.
• INFANTS CAN SUFFOCATE ON SOFT BEDDING.
• NEVER ADD A PILLOW, COMFORTER OR PADDING.
• NEVER PLACE ADDITIONAL PADDING UNDER INFANT.
• NEVER USE PLASTIC SHIPPING BAGS OR ANY PLASTIC FILM AS MATTRESS COVERS, BECAUSE THEY CAN CAUSE SUFFOCATION.
• INFANTS CAN SUFFOCATE IN GAPS BETWEEN CRIB SIDES AND A MATTRESS THAT IS TOO SMALL. ANY MATTRESS USED IN THIS CRIB MUST BE  AT LEAST 27-1/4 IN (69 CM) BY 51-5/8 IN (131 CM), WITH A THICKNESS NOT EXCEEDING 6 IN (15CM) AND A MINIMUM THICKNESS OF 4 IN (10 CM).  THE DIMENSIONS OF THE MATTRESS SHALL BE TAKEN FROM SEAM TO SEAM OR EDGE TO EDGE WHERE APPROPRIATE.
FALL HAZARD
• WHEN THE CHILD IS ABLE TO PULL TO THE STANDING POSITION, SET THE MATTRESS TO THE LOWEST POSITION AND REMOVE BUMPER PADS, LARGE TOYS, AND  OTHER OBJECTS THAT COULD SERVE AS STEPS FOR CLIMBING OUT. AFTER RAISING THE SIDE, MAKE SURE LATCHES ARE SECURE (DISREGARD FOR  NON-DROP SIDE CRIB).
• DO NOT LEAVE CHILD IN CRIB WITH SIDES LOWERED. BE SURE THE SIDE IS IN RAISED AND LOCKED POSITION WHENEVER THE CHILD IS IN CRIB  (DISREGARD FOR NON-DROP SIDE CRIB).
• STOP USING CRIB WHEN CHILD BEGINS TO CLIMB OUT OR REACHES THE HEIGHT OF 35 IN (89 CM).
• WHEN STORING A CRIB USE CAUTION AS EXTREME CHANGES IN TEMPERATURE OR HUMIDITY CAN COMPROMISE THE CRIB MAKING IT  EXTREMELY DANGEROUS TO YOUR CHILD.
• USE CAUTION WHEN A VAPORIZER OR HUMIDIFIER IS IN USE. ALWAYS AIM VAPOR AWAY FROM THE CRIB AS WELL AS ANY OTHER WOODEN  FURNITURE. PROLONGED PERIODS OF HUMIDITY IN STORAGE AS WELL AS IN THE HOME CAN COMPROMISE THE CRIB.
• AVOID USING VAPORIZERS AND HUMIDIFIERS FOR PROLONGED PERIODS OF TIME.
• FOLLOW WARNINGS ON ALL PRODUCTS IN CRIB.

WARNING

• Do not use this crib if you cannot exactly follow the accompanying instructions
• Do not use this crib for a child who can climb out of it or who is taller than 90 cm
• Do not place in or near this crib any cord, strap, or similar item that could become wrapped around a child’s neck
• Do not place this crib near a window or a patio door where the child could reach the cord of a blind or curtain and be strangled
• Ensure that the sides of this crib are properly latched or locked inappropriate position where the child is left unattended in it
• Check this crib regularly before using it and do not use it if any parts are loose or missing or if there are
any signs of damage. Do not substitute parts. Contact the manufacturer if replacement parts or
additional instructions are needed
• Use a crib mattress that is no thicker than 15 cm and is of such a size that, when it is pushed firmly against any side of the crib, it does not leave a gap of more than 3 cm between the mattress and any part of the sides of the crib.
• Children can suffocate on soft bedding. Do not place pillows, comforters, or soft mattresses in this crib.

Furniture Care Instructions

Room Climate Control

Wood, when the first cut contains more than 50 percent water. When it is prepared for furniture construction it is placed in a Kiln and the moisture content is brought down to 8 to 10 percent. Wood is porous and responds to its environment. If the room has high humidity it will absorb it and expand and if the humidity is low it will lose moisture and shrink.

It is important that the humidity levels in the room be controlled from extremes of too much humidity or too little. Furniture should not be placed close to air-conditioning outlets, fireplaces, radiators, space heaters, humidifiers, or dehumidifiers. Exposure to extreme variations of temperature and humidity can damage any fine wood product.

The Ideal Environment for Fine Furniture

Fine wood furniture will have fewer problems when its environment is controlled at a temperature between 65 and 75 degrees and relative humidity between 35 and 40 percent. Wood placed in an environment outside of those limits can and will shrink or expand and may develop some small

cracks that are not material or structural defects.

Sticking Doors and Drawers

With the minor changes in temperature and humidity doors and drawers may swell and be difficult to open or close. Tolerances have been built into the units but extreme conditions may still cause sticking. This will adjust back to normal over time but until it does consider using a dehumidifier or rub candle wax or paraffin on the sides that stick.

Avoid Direct Sunlight

Keep the furniture out of direct sunlight. Ultraviolet rays will fade colors and in some cases darken them. It can also cause crazing or hairline cracks in the finish. White finishes will yellow naturally over time and exposure to direct sunlight will hasten this natural process along with some woods darkening naturally over time; this is not considered to be a quality defect.

Proper Storage

If you need to put your furniture in storage for any period of time do not store them in a damp basement or hot dry attic. Allow air movement around the furniture and do not stack anything on it.

In General

• Protect furniture surface from hot or extremely cold items.
• Use coasters under hot or cold beverages
• Do not use synthetic fabric under accessories or lamps
• Protect tops from pens, makers and crayons
• Oils from potpourri and other scented items can damage the furniture finish.
• Do not drag items across the surface of the furniture.
• Allow the surface to breath by rotating your accessories and lamps.
• Do not over polish the furniture, do it only two or three times a year.

Over polishing can distort the natural finish of the product.

• Do not wax the furniture as wax build up can destroy the natural finish of the product
• When moving furniture always lift the unit. Do not push or drag it to avoid damage to legs
• Keep the furniture level so doors and drawers open and close freely.
• Clean with a damp, not wet, cloth. Use only a mild soap. Do not use abrasive cleaners.

ASSEMBLY INSTRUCTIONS

Parts Enclosed In Carton

HARDWARE AND TOOL DIAGRAM

STEP  1

STEP 2

STEP 3
STEP  4

Day Bed Conversion

WARNING
WHEN CONVERTING THIS CRIB TO A DAY BED,

In order to convert your crib to a day bed, you must first remove the front rail of the crib, then attach the stabilizer bar, using the bolts from the front rail removal.
NOTE: Make sure the mattress support is in the lowest position. Please follow the complete instructions that come with the guard rail which is sold separately.

Guard Rail and Stabilizer Bar (Not Included, Sold Separately)

WARNING
WHEN CONVERTING THIS CRIB TO A TODDLER BED,
A GUARD RAIL AND STABILIZER BAR MANUFACTURED BY ÉVOLUR INC,
MUST BE USED.
In order to convert your crib to a toddler bed, you must first remove the front rail of the crib, then attach the guard rail using the bolts from the front rail removal.
NOTE: Make sure the mattress support is in the lowest position.
Please follow the complete instructions that come with the guard rail which is sold separately.

Guard Rail and Stabilizer bar (Not Included, Sold Separately)

Bed Rails (Not Included, Sold Separately)

WARNING!
For Toddler Bed Use

• FAILURE TO FOLLOW THESE WARNINGS AND ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH FROM ENTRAPMENT  OR STRANGULATION.
• DO NOT PLACE A BED NEAR WINDOWS WHERE CORDS FROM BLINDS OR DRAPES MAY STRANGLE A CHILD.
• THE MATTRESS INTENDED FOR USE ON THIS BED SHALL BE A FULL-SIZE CRIB MATTRESS HAVING THE DIMENSIONS OF 51-5/8 IN (1310 MM) IN LENGTH AND 27-1/4 IN (690 MM) IN WIDTH AND THICKNESS OF 4 IN (100 MM) OR A GREATER THICKNESS AS SPECIFIED BY THE MANUFACTURER.
• THE MINIMUM AGE OF THE INTENDED USER SHALL NOT BE LESS THAN 15 MONTHS AND THE MAXIMUM WEIGHT SHALL NOT BE GREATER THAN 50 LBS. (22.7 KG).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>