Colorsmoon LED Floo Lamp User Manual
- June 7, 2024
- Colorsmoon
Table of Contents
Colorsmoon LED Floo Lamp
Specifications:
Model | FL1-BK |
---|---|
Rated Power | 20W |
Input Voltage | 100-240V AC 50Hz/60Hz |
Output Voltage | DC 12V 1.5A |
Type of Light | LED |
CCT | 3000K,4500K,6000K |
CRI | >80Ra |
Lumen | 2200LM |
Dimension of light | D282*H1800mm |
Packaging list:
- CD Lamp Base
- Pole 1
- Pole 2
- Pole 3 with control panel
- Pole 4 with lamp A
How to Use:
- Place the lamp base on flat surface.
- Screw the pole 1 into the lamp base.
- Pull the power cable from the lamp base and then screw the pole 2 to pole 1.
- Pull the power cable from the lamp base again and screw the pole 3 to pole 2 ( Careful not to remove the bar rubber grommet).
- Screw the pole 4 to pole 3 (Any excessive cord slack has to be pulled towards the lamp.)
- Finished and you are ready to use.
Notice:
- **** Please pull power cable from bottom lamp base rather than from the top.
- Any top cord extra slack should to be pulled towards the lamp rather than into pole 3
- The two tiny plug adapters should be firmly attached on the both ends of pole 3, please don’t remove it
- Wires twist may cause the bulb to cut off, please take care to not pinch or damage the wires
- Make sure each section of the tubes are tightened.
Operation Instructions
Manual Control
- Increase the brightness
- Decrease the brightness
- Switch between the color temperatures 4 Power ON/OFF.
Remote Control
See the chart as below
Note:
- Button ”DIMMEST 5°/o” means you set the light to its lowest brightness for night light use.
- You must point the remote to the touch panel to control the light.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>