PUNKS Monopod Instruction Manual
- June 7, 2024
- PUNKS
Table of Contents
PUNKS Monopod
Look at the end of your box. See that little sticker with a serial number and
a barcode? Peel it off and put it here for safe keeping.
Or don’t.
IMPORTANT:
DO NOT USE YOUR MONOPOD UNTIL YOU HAVE READ THESE INSTRUCTIONS. NO WARRANTY
CLAIM WILL BE ENTERED INTO FOR THE MISUSE OR INCORRECT USE OF THESE PRODUCTS.
ANATOMY OF A MONOPOD
- Retractable Screw Mount
- Mounting Plate
- Bubble Grip
- Leg Section
- Twist Locks
- Boot / Footwear
Always hold your camera when removing from the monopod!
Using The Monopod
To open and extend the monopod simply grip the twist locks (5) in your hand, quarter turn, loosening the monopod allowing you to select a desired height. Once the required height has been obtained lock the monopod in place by rotating back to the original position, which will fully engage the leg lock. The twist locks do not require to be undone further than a half turn, unless you intend to completely disassemble the monopod for cleaning.
To attach your camera, ballhead, or accessory, insert the mounting screw (1) into the base of your cam-era. If your camera has a 1/”-20 thread, retract the spring-loaded sleeve on the screw to reveal the smaller thread, then insert into the base of your camera. Turn the monopod until the screw meets resistance. Do not over-tighten.
The Mounting Plate comes with one 3/8” threaded screw in the centre. The outer part can be retracted to reveal the 1/4” thread in the centre.
ANATOMY OF DOCZ
- 3/8”-16 Screw Thread
- Screw Lock
- Ball
- Legs
- Leg Buttons
- Rubber Boot / Ball Adjuster
- Rubber Feet
Using Docz
To open the legs from folded, pull down until they click into place. To
fold them back up, press the button (5) at the base of each leg and fold
upwards.
To attach to a monopod unscrew the rubber Boot and the adapter in the base of
the monopod. If this adapter is stuck, you can remove this by using tools, or
a coin, and turn it anti-clockwise. Put the adapter somewhere safe!
Once removed, insert Docz’ orange screw thread (1) into the base of the
monopod and turn until the screw meets resistance. If you want to adjust the
ball position, turn the orange screw lock (2) upwards until it meets the base
of the monopod. To adjust the ball (3) position, loosen the rubber Boot (6) on
the base of Docz. Angle the monopod to the desired position. Tighten the Boot
(6) to lock the ball into place.
Cleaning
It is advised that you wash your monopod after using it in sand, or dirt.
For videos on how to clean your 3 Legged Thing products, please visit:
https://www.3leggedthing.com/faq
Never use WD40 on your monopod as it can be a solvent. Always use silicone
grease.
Warranty Information
Your 3LT product comes with a 5 Year Global Warranty. On the box you will find
a sticker with a unique barcode and serial number. Use this serial number to
register your products at
www.3leggedthing.com/register.
Details of your warranty can be found at
www.3leggedthing.com. Your warranty covers 3
Legged Thing products only.
If you have a question or suspect you have a fault, contact us first at
support@3leggedthing.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>