YUJIN ROBOT TOP-4512AC-U iClebo Arte Robot Vacuum Cleaner User Manual
- June 4, 2024
- YUJIN ROBOT
Table of Contents
TOP-4512AC-U iClebo Arte Robot Vacuum Cleaner
User Manual
INSTALLING & REMOVING WiFi Module
-
Press the depression at the top of the robot vacuum cleaner.
The lid of the storage compartment will open. -
Unlatch the dust box by lifting the handle upward
-
Remove the dust box
- Pull the cover out from the front.
- Insert or Remove the WiFi module.
- Put the cover back on.
Note
You can connect the robot vacuum cleaner directly to a mobile device without a
WiFi network.
To do this, connect the mobile device to the robot vacuum cleaner’s WiFi.
Use the robot vacuum cleaner’s serial number as the WiFi password.
You can find the serial number on a sticker in the storage compartment and on
the data plate on the underside of the robot vacuum cleaner. Follow the
instructions in the app.
FCC Information to The User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution
THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY
APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD
VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
IMPORTANT NOTE : FCC RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device can only be mounted and used on a robot vacuum cleaner.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>