U-BOAT CHRONO Smartwatch Instruction Manual
- June 3, 2024
- U-BOAT
Table of Contents
U-BOAT CHRONO Smartwatch
- WE CONGRATULATE YOU ON THE PURCHASE OF THIS U-BOAT WATCH.
- IN THIS BOOKLET YOU WILL FIND THE INSTRUCTIONS FOR USE.
- WE KINDLY INVITE YOU TO REGISTER YOUR WATCH ON OUR OFFICIAL WEB SITE IN THE U-CLUB AREA, DEDICATED EXCLUSIVELY TO THE U-BOAT WATCHES OWNERS AND GAIN ACCESS TO FURTHER BENEFITS AND PREVIEWS ON OUR LATEST NEWS, EVENTS AND OFFERS.
WATCH INSTRUCTIONS
- A. CAP CROWN
- B. RESET THE CHRONO
- C. 24 H COUNTER (PM-AM)
- D. CHRONOGRAPH HOUR COUNTER
- E. CHRONOGRAPH SECONDS HAND
- F. CROWN
- G. HOUR HAND
- H. MINUTE HAND
- I. CHRONOGRAPH MINUTE COUNTER
- J. START/STOP CHRONOGRAPH
- K. SECONDS COUNTER
- L. CROWN EXTRACTION BUTTON
- M. DATE
-
POSITION 1
NEUTRAL POSITION -
POSITION 2
FIRST CLICK -
POSITION 3
SECOND CLICK
INSTRUCTIONS FOR USE
-
Unscrew the cap crown A to gain access to the crown F .
-
POSITION 1: NEUTRAL POSITION
to wind and start the watch by turning the crown F clockwise. -
POSITION 2: FIRST CLICK
press button N to move the crown F into position 2 (first click).
Turn the crown F clockwise to set the date O . -
POSITION 3: SECOND CLICK
press button N again to move the crown F into position 3 (second click) and turn the crown F to set the exact time. Use indicator C for correct date change O.
-
-
Fully depress the crown F to move it back into the neutral position. Carefully screw in the cap crown A until firmly in place.
IMPORTANT
To prevent misalignment or breakage of the date wheel when setting the date,
make sure that:
- During manual adjustment of the date O , hour hand G is not pointing between 9 pm and 3 am (check the 24 hour hand C ).
- The day indicated by the date indicator O is aligned with the window (see the picture next)
- Take the crown F out to the second click, move the hand G to 3 pm, depress the crown F to the first click and move the date indicator O to the desired date and check the alignment as indicated in point 2 above.
CHRONOGRAPH OPERATION INSTRUCTIONS
- Press button L (start/stop) to start the chronograph and the hour/minute counters.
- Press button L again to stop the chronograph and once more to restart it.
- After noting the time measured, press reset button B when the chronograph is stopped to return the chronograph hand and counters to zero.
CARE AND MAINTENANCE
- The precision mechanism in your watch will provide long-lasting performance when properly cared for.
- We recommend taking your watch to an Authorised Retailer/Authorised Service Centre every 3-4 years for a check-up and to perform ordinary maintenance on all mechanical parts and restore of water-resistance.
- We also advise taking your watch to an Authorised Retailer/Authorised Service Centre to change the strap.
- Avoid leaving your watch where it is exposed to large temperature variations, humidity, the sun and strong magnetic fields.
- Make sure the watch is in adequate conditions for water use/activities.
- Remember to rinse the watch after it comes into contact with seawater.
AUTOMATIC WATCHES REQUIRE MANUAL WINDING FOLLOWING A LONG PERIOD OF INACTIVITY.
ABOUT COMPANY
- Via Pesciatina 751H
- Gragnano, Capannori
- 55010 Lucca – Italy
- Tel: +39 0583 469288
- Fax: +39 0583 462249
- www.uboatwatch.com
- service@u-boatwatch.com