U2o Global DBL1000M Rechargeable Docking Backup Battery for iPod and iPhone User Guide
- June 6, 2024
- U2o Global
Table of Contents
DBL 1 0000M
Welcome Guide
Focus On True Value
US 1-888-961- 5888 | 24/7 service
@iWALKUSA
U20 GLOBAL CO.,LTD.
.40Me020gig/l.hf%43.8./Fi.Chi
Made in china PA 1179
Product Introduction
It takes about 6 seconds to start up the wireless charging by pressing the button. It is the normal startup tire, please wait a little bit when using this product to charge the mobile phone, in or0er to $av8 the mobile power $up9// po0wot, its 80o0Doored to 008008l double-click the button after charging. hen charging or not using the mobile phone at night, there is no need to manually shut down, waiting for the mobile power supply to tum off automatically
Safety Precautions
To preserve battery lites.pen, u 80 recharge at le8t 0008
6wry4mouths
-Lise original or oert/fed cables
– Do not expose to liquids
Do not disassemble
– Ahold dropping
Avoid extreme temperatures
– Do not leave for a long tire during charging
Specifications
Product Narmer LinkMe 10000 Mag
Model No. DBl1 0000M
Capacity. 900Om (3.70/33.3w)
lout: 0S8-C5we3A,9Ne2A,12V1.5A
Output: U8–CV=3A9vr2A,20154
Wireless Chorging 5W/7.54/104/15¥
Sier 6009028.Smm
Weight 203g
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
![U2o Global DBL1000M Rechargeable Docking Backup Battery for iPod and iPhone
- pass charging](https://manuals.plus/wp-content/uploads/2021/12/U2o-Global- DBL1000M-Rechargeable-Docking-Backup-Battery-for-iPod-and-iPhone-pass- charging-243x300.png)
Notes for use
You cannot charge equipment wirelessly under the following conditions
— The used mobile phone case is too thick (more than 6 mm).
— Do not use adapters with an output power of 5V-1 A(5W) or less.
— Compared to wired chargers, wireless chargers are more convenient when charging, but due to the limitations of current wireless technology, the charging speed is slower than wired chargers.
— High temperatures will slow down the charging speed and limit the charging power, which is common to all wireless chargers.
— Charging equipment at temperatures below 26°C is recommended.
— The position of the mobile phone case and equipment on the wireless charger can affect the charging speed, The farther the equipment is positioned on the wireless charger from the center, the slower it will be charged.
– No lo desmonte.
– Evitar la caida del producto.
– Evite el use del presente a temperaturas demasiado bajas o demasiado altas.
– Durante el proceso de carga del producto, el personal no debe salir durante mucho tiempo.
For a Class B digital device or peripheral, the instructions furnished the
user shall include the following or similar statement, placed in a prominent
location in the text of the manual:
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna. —Increase the separation between
the equipment and receiver. –Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. –Consult the dealer or
an experienced radio/TV technician for help.
Warranty card
Thank you for purchasing the new LK product. Our product’s warranty period is
12 months starting from the date of purchase. Within the warranty period, free
service will be provided to the sailer. if the product has any quality
problems(requiring warranty card with distributor’s official stamp and valid
S/N).
Paid service: customer will incur a repair charge as follows: -No valid
warranty card or warranty card incompatible. -No S/N or S/N incompatible with
warranty card -Malfunction caused by artificial damages(like external impact
or submerging product into water, etc.) -Misuse of the product. The user has
not followed the instructions in the manual. -Product disassembled or repaired
by an individual or unauthorized service center. -Damages are caused by
storing the product in a hot or humid environment. -Defects or malfunctions
due to force majeure.
Warranty card
Thake you for purchasing the W LK product Or product’s warranty period is 12months starting from the date of purchase. Within the warranty period. free service will be provided to the seller. if the product has any quality problems(requiring warranty card wit distributes offed stamp aid valid
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>