Shenzhen Deshengxing Industrial S1 Wireless Charger User Manual
- June 6, 2024
- Shenzhen Deshengxing Industrial
Table of Contents
Shenzhen Deshengxing Industrial S1 Wireless Charger User Manual
Please Read This Manual Carefully Before Using This Product and Keep It Properly
Product Description
Specific Parameters
Product Name: Wireless Charger
number: S1
Input Interface: 5V2A /9V 2A
Wireless output: 5W/10W/15W
Product Size: 105X67X15mm
Product Weight: 135g
Executive standard: GB/T35590-2017
Product List
Data line 1
Synopsis 1
Ring steel sheet* 1
The name and content of hazardous substances in the product
In order to meet my country’s relevant laws, regulations and other requirements on the restriction of hazardous substances in electrical and electronic products, the hazardous substances in this product are classified by composition, and the statement is as follows
This form is compiled in accordance with the regulations of SJ/T11364. Some models of products may not include this form.component.
O: Indicates that the content of hazardous substances in all homogeneous materials of this part is below the limit requirement of GB/T26572.
X: Indicates that the content of hazardous substances in at least one homogeneous material of this part exceeds the limit requirement of GB/T26572.
Note: This product is marked with X because there is no alternative technology or component to choose from at this stage. Please handle such parts or substances properly to avoid impact on the environment and human health. The printed circuit board assembly includes the printed circuit board and its parts, capacitors and connectors.
Entrusted manufacturer: Shenzhen Deshengxing Industrial Co., Ltd.
Address: No. 121, Hongyin Road, Qinghu Street, Guangming New District, Shenzhen.
This information is for reference only and does not constitute any form of commitment; products (including but not limited to color, size, etc.) please refer to the actual product
Warranty Card
For your rights, please fill in carefully and keep it properly as a proof of maintenance.
Note: The machine comes with accessories, which are not covered by the warranty.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.