GLOVES B07XDL8BSW Tech Tools Punching Instruction Manual
- June 6, 2024
- GLOVES
Table of Contents
|
ASSEMBLY INSTRUCTION
---|---
1. Insert top plastic fitting(F) into the top of the base unit(G) and
position the steel washer with a large hole(E) on top.
2. Insert lower section(D) through washer(E), fitting(F), and base unit(G).
3. Insert bottom plastic fitting(H) into the bottom side of base unit(G) and
secure firmly in place with large steel washer(I), spring washer(J), and
screw(K), with a screwdriver into bottom of the lower section(D).
4. Fill the base unit with sand or water, then insert the cap.
5. Click mid-section(C) into lower section(D) ensuring butterfly screw is
uppermost.
6. Insert top section(B) into mid-section(C) and set to the desired height
using butterfly screw to secure.
7. Inflate punching ball(A) using the pump provided(DO NOT OVER INFLATE),
then screw securely by hand into position at top of section(B).
8. Use well away from obstacles, breakable items, or other hazards.
WARNING: This item should be assembled by an Adult.