Shellbot SL60 Robot Vaccum Cleaner Instruction Manual

SL60 Robot Vaccum Cleaner
Instruction Manual

Security Information

Important safety instructions
When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEF­ ORE USING  (THIS APPLIANCE), Failure to follow the warnings, and in­ structions may result in electric shock, fire and/or serious injury.

WARNING

• This product only applies to the cleaning of house floors, and should not be used in outdoor areas (e.g., balcony), areas other than floors (e.g., sofa), or commercial or industrial environments.

• Do not use the product in environments (e.g., duplex floor, top of furniture) that are not equipped with guardrails, so as to avoid prope­ try and personal injury caused by equipment falling.

• Do not use the product in environments where the temperature is above 40Cor below0C

• Do not use the product in environments where any liquid or slime exists on the floor.

• Please clean up debris or scattered small objects and cables on the ground before use to prevent the robot from being blocked or entan­ gled during operation.

• Before use, please ensure that fragile, ticklish, precious, or potentially dangerous articles are properly stored to avoid personal injury or
  property loss caused by the robot during work.

• Never allow any persons with physical, mental or perceptual disord­ ers (including children) to use or operate this product

• Please properly place this product, charging dock, and product acc­essories to prevent children from touching it so as to prevent person­ al and property damage.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervi­sion or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

• Do not place human hair, clothes, fingers, and other parts close to the suction port and operating parts of the product

• Never use the product to absorb any burning articles, such as cigar­ettes, matches, ashes, and other articles that may cause a fire.

• Never use the product to absorb anything that may block the produ­ct, such as stones, waste paper, nails, broken glass, etc.

• Please clean and maintain the robot and the charging dock in the shutdown or power-off state.

• Please use a dry and soft towel to clean the charging dock and the product It is strictly prohibited to wipe any part of the product with any wet cloth, detergent, or liquid.

• Please observe the work of the robot during the use the first time and help to deal with some possible problems: such as twisted cab­les, uneven areas, areas that may cause the robot to hang in the air or become stuck, and so on.

• Please use this product in strict accordance with the product instru­ctions. Any loss or injury caused by improper use shall be on the user’s own account.

• The laser radar of this product complies with the requirements of IEC 60825-1:2014 on the safety of Class 1 laser products; it will not produce laser radiation harmful to human health.

• Do not let children consider the robot a toy, and let them away from the machine when it is working.

• Do not put your children, pets, or anything on the machine, whether it is working or not.

• Please put the cleaning brush out of the children’s reach.

• Please do not use the laser radar protective cap as a handle to move the machine.

• Please do not place on the ground the machine upside down for a long period.

• Please follow the instructions when using the product, and use accessories recommended or sold by the manufacturer ONLY.

• Please make sure that the dust box and filtering materials have been assembled in place.

• Do not handle chargers, including charger plug, and charger terminal­ s with wet hands.

• Do not put any finger into the gap of the machine to avoid an injury.

• This device has been designed to be used on floors without scratch­ ing them. We still recommend that you test this device on a small ar­ ea of the room to be cleaned to ensure no scratches are made before cleaning the whole room.

Battery and Charging

• Do not use any third-party battery, charger, or charger.
• Please ensure the correct voltage is used.
• Never attempt to remove, repair or modify the battery on the charging dock.
• Please do not place the charging dock and the robot near the heat source, such as the radiator, induction cooker, and oven.
• Do not use a wet cloth or any liquid to wipe this product.
• Do not dispose of waste batteries at will. It is suggested to hand them over to a professional organization for treatment.
• If the power cord is damaged or broken, please stop using it immedi­ately and contact us in time to choose a regular channel to purchase a genuine power cord for replacement.
• Transport the product in power-off state in the original packaging box.
• If the product is to be left unused for a long time, please power off the robot after full charging, and store it in a cool and dry place; recharge it at least every 3 months to avoid battery damage.
• The battery must be removed from the robot before the product is discarded. When taking out the battery, the robot must be powered off. After taking out the battery, the battery should be disposed of safely.
• Burning the product is critically prohibited even if it has been severe­ly damaged, since the battery may explode due to combustion.

WARNING: For the purposes of recharging the battery, only use the detachable supply unit provi­ded with this appliance.

Notice:
The symbol on this product or its packaging indicates that this device cannot be disposed of as unsorted municipal waste. To dispose of such devices, you need to use separate collection facilities. Contact your local authority for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dump hazardous substances can leak into the groundwater and get into the food Chain, damaging your health and well-being. Please contact your local or regional waste authority for more information on collection, reuse and recycling programs.

FCC Statement

Changes or modifications not expressly approved by the party respon­sible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer­ence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC rules. Operation is subj­ect to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

Product Introduction

Main machine

Instructions on indicator lights

Status
Sleep/Powered off
Idle/Working/Pausing
Launching/Upgrading
Configuring network| Light type
Light out
Always-on blue light
Breathing blue light
Flashing blue light| Status
On the way to recharging
Recharging
Malfunction| Light type
Slowly flashing yellow light
Breathing yellow light
Fast flashing red light
---|---|---|---

Main machine

This manual picture is for reference only, the actual appearance please prevail in kind.

Parts List

Other Accessories

Product Introduction

Two-in-one water tank
(To be used in both sweeping and mopping mode)

Dustbin

Dust tank (To be used in the sweeping mod)

Charging dock

Duster component

Remote control

Modes
The first time the robot is operated, it will map and memorize the whole house by means of its laser before starting the cleaning cycle.
Note: make sure the light indicator it lit up in blue before starting cleaning indicating it is activated.
If it is not, press any button on the remote control to wake it up.

Pairing mode:
If the remote control cannot control the robot, please follow the steps below:

1. Press the remote control” Water output adjustment “button 5S, the remote control enters the pairing mode, the screen displays 8888;
2. The remote control receiver module is powered on within 5s and enters the pairing mode. At this time, the pairing signal of the remote, control­ is received, and the remote controller returns to normal, the clock shows that the pairing is completed.
3. If the pairing is unsuccessful, the remote control will display 8888, and will automatically exit the pairing mode after 30S.

Product Introduction

Current time

1. Long press the button. The first 2 digits, indicating the hour, will start blinking.
   Use the up and down direction buttons to set the current time.

2. Use the left and right buttons to switch from hours to minutes and repeat the before step.

3. Press the button again to save the settings.

Cleaning scheduling

1. Long press the button. The first 2 digits, indicating the hour, will start blinking.

2. Use the up and down direction buttons to set the current time.
   Use the left and right buttons to switch from hours to minutes and repeat the before step.

3. Press the button again to save the settings.

4. To cancel the scheduled cleaning: Set the scheduled times to 00:00 and save it.

Note:
The robot will emit two beeps to indicate all settings have been saved.
WARNING:
When the remote control’s batteries are replaced, the clock and schedule times must be set again.

Installation Instructions

Important Tips Before Use

1. Remove every object that might entangle the robot such as curtains strings, power cords, nails, etc …
2. Robots may climb on top of objects less than 0.71 in/18 mm in height. Remove these objects if possible.
3. Keep the robot away from wet areas.
4. Keep the robot away from spaces lower than 3.94 in/100mm to prevent the robot from getting stuck If necessary, place a physical barrier to block off the problem areas.
5. Fold tasseled edges of area rugs underneath to prevent tangli­ng robot. Avoid cleaning very dark-colored high-pile rugs. or rugs thicker than 1.02 in/26 mm as they may cause the robot to malfunction.
6. Anti-drop sensors prevent robots from tumbling downstairs and steep drops. They may work less effectively if dirty or used on reflective/very dark-colored floors.
   It is recommended to place physical barriers to block off areas where Robots may fall.

Tips:
Place physical barriers in from of areas that. might damage the robot such as fireplaces, heaters, pools, etc …

Installation Instructions

1. To remove the protective strip of the machine.
   

2. To remove the protective membrane on the visual sensor.
   

3. To remove the protective membrane around the charger base.
   

4. To assemble the side brush.
   

5. Install AAA batteries into the remote.

Product Parameters

Charging Dock Parameters

Names and Contents of Harmful Substances in Products

Hazardous substances

Part name

| Pb| Hg| Cd| Cr(VI)| PBB|

PBDE

Printed circuit boards

| X| 0| 0| 0| 0|

0

Metals

| 0| 0| 0| 0| 0|

0

Shell

| 0| 0| 0| 0| 0|

0

Standard parts

| 0| 0| 0| 0| 0|

0

Other structural parts

| 0| 0| 0| 0| 0|

0

O: Indicates that the content of this hazardous substance does not exceed the percentage of the reference value of presence.
X; Indicates that the restricted substance corresponds to the exemption.
Long-term use of the product will not cause harm to human health.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>