CYBERNETYX BRDHU01 Bird Hub User Manual
- June 6, 2024
- CYBERNETYX
Table of Contents
**CYBERNETYX BRDHU01 Bird Hub User Manual
**
Components for Setup
In the box
- Thinker Connect
- 2.5m Micro USB to USB Type A Cable
- 1m Power Cable
- Power Adapter
- Stylus with Charging Cables
Not in the box
- HDMI Cable
- Measuring Tape
- Marker
- Display Panel
- Computer
Installation
Basic Guidelines
Take care not to place the panel in direct sunlight.
For seamless experience the display panel has to be mounted firmly. If needed,
add some extra padding (ex: sponge) for support between the panel and the wall
to prevent it from shaking while writing.
Measure and mark the centre and top list of the display. Place Thinker Connect
on the display and use the clip to fix it safely on the display. Make sure
Thinker Connect is not leaning forward or falling behind.
Connectivity
**Port Description
**
**Connections
**
Setting Up
Installing Drivers
Go on: airmind.ai/downloads and download
EyeRIS Drivers
Flow Software
Run the downloaded files, setup window will guide you to install the software.
Calibration
Launch EyeRIS drivers and click on
**Auto Calibration
**
Stylus
**Description
**
Charging
Note Styluses needs to be charged before using for the first time.
To charge stylus use the Mini USB Cable and connect the stylus to PC
Registered Offices
Hannover: Georgstrage 38, 30159, Hannover, Germany,
Ph: +49 (0)511 93621 188
Delhi NCR: Plot no. C-98, Sector- 65, NOIDA, 201301,
Ph: +91 (0)120 435 9466
Bangalore: 1140, Sector 7, HSR layout, 560102, India,
Ph: +91 (0)888 474 3388
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be
co‐located for operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>