HomElectrical PQL-93803 LED Snap and Go Kit Magnetic Modules Instruction Manual
- June 6, 2024
- HomElectrical
Table of Contents
PQL-93803 LED Snap and Go Kit Magnetic
Modules
Instruction Manual
PREMIUM QUALITY LIGHTING
PLEASE FIND A QUALIFIED ELECTRICIAN FOR INSTALLATION. Please read the
instructions before you install and use the Snap & Go™ kit.
FOLLOW ALL WARNING INSTRUCTIONS
DANGER – RISK OF SHOCK – DISCONNECT POWER BEFORE INSTALLATION
WARNING – Risk of fire or electric shock. LED Retrofit Kit installation
requires
knowledge of luminaires’ electrical systems. If not qualified, do not attempt
installation.
WARNING – The product must be installed in accordance with the National
Electrical Code or your local electrical code. If you are not familiar with
these codes and requirements, contact a qualified electrician.
WARNING – Risk of fire or electric shock. Install this kit only in the
luminaires that have the construction features and dimensions shown in the
photographs and/or drawings and where the input rating of the retrofit kit
does not exceed the input rating of the luminaire.
WARNING –To prevent wiring damage or abrasion, do not expose wiring to edges
of sheet metal or any other sharp objects.
WARNING – Risk of fire or electric shock. Check the existing wiring and
components for damage before installing the upgrade kit.
WARNING – Do not make or alter any open holes in an enclosure of wiring or
electrical components during kit installation.
Do not install if existing wires are damaged.
Suitable for damp locations and for use in totally enclosed luminaires.
GENERAL SAFETY INFORMATION
Review the diagrams thoroughly before beginning.
Before installation, disconnect the power by turning off the circuit breaker
or by removing the appropriate fuse at the fuse box. Turning the power off
using the light switch is not sufficient to prevent electrical shock.
The retrofit kit should be mounted in locations and at heights where it will
not readily be subject to tampering by unauthorized personnel.
WARNING DISCONNECT POWER BEFORE INSTALLING OR SERVICING.
-
Remove the lens or louver (if required).
-
Disconnect wires and remove the original fluorescent tube(s) and ballast from the existing fixture. (Recycle tubes according to state-specific recycling guidelines).
-
Install Snap & Go™ Magnetic Modules; using optional mounting clips (#93748) if necessary. (Sold separately)
-
Install Snap & Go™ driver.
-
Connect driver’s input line: Dim +, Dim – and module lines.
-
Replace lens or louver, if needed.
PREMIUM QUALITY LIGHTING® • www.PQLighting.com
© P.Q.L., Inc. • 2285 Ward Avenue • Simi Valley, CA 93065 •
800-323-8107
Specifications are subject to change without notice. Photos and line drawings
may not be to scale and are for general reference only.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>