IKEA 304.065.41 TRÅDFRI Remote Control Kit White Spectrum Instruction Manual
- June 6, 2024
- Ikea
Table of Contents
TRÅDFRI
REMOTE CONTROL FUNCTIONS
ON/OFF: Press to turn your light source on and off.
Press and hold for at least 3 seconds to synchronize your lights.
Dim up/down: Short presses will dim up/down in steps. To dim up/down
seamlessly, press and hold the button.
Change white spectrum, colors or scenes.
Pairing: Add IKEA Smart Lighting products to your system. See instructions
below.
ADDING DEVICES TO YOUR REMOTE CONTROL
When the remote control is sold together with a light source (in the same
package), they are already paired. If the remote control is purchased
separately, you must manually pair it to your light source.
To add light sources, just repeat the steps below.
- Make sure that your light source is installed and the main power switch is turned on.
- Hold the remote control close to the light source you want to add (no more than 5 km away).
- Press and hold the pairing button for at least 10 seconds. A red light will shine steadily on the remote control. Your light source will begin to dim and flash one time to indicate that it has been successfully paired.
Up to 10 light sources can be paired with 1 remote control. Make sure to pair them one at a time. If the light sources are close to each other, disconnect those that have already been paired from the main power switch.
FACTORY RESET YOUR DEVICES
For light sources:
Toggle the main switch 6 times.
For remote control:
Press the pairing button 4 times within 5 seconds.
SYNCHRONIZING
If your light source becomes unsynchronized, press and hold the ON/OFF button for at least 3 seconds to return the light source to its default setting (100% brightness, 2700K).
CHANGING THE BATTERY
When the remote control is used regularly and as intended, the batteries will
last for approximately 2 years.
When it’s time to replace the battery, a red LED indicator will flash when you
press any button on the remote control.
Open the battery lid and replace the battery with a new CR2032 battery.
CAUTION!
Risk of explosion if the battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
IMPORTANT!
- The remote control is for indoor use only and can be used in temperatures ranging from 0ºC to 40 ºC.
- Do not leave the remote control in direct sunlight or near any heat source, as it may overheat.
- The range between the remote control and the receiver is measured in the open air.
- Different building materials and placement of the units can affect the wireless connectivity range.
CARE INSTRUCTIONS
To clean the remote control, wipe with a soft cloth moistened with a little
mild detergent. Use another soft, dry cloth to wipe dry.
NOTE!
Never use abrasive cleaners or chemical solvents as this can damage the
product.
TECHNICAL DATA
Type: E1810 TRÅDFRI Remote
Input: 3.0V, CR2032 Battery
Range: 10 m in the open air.
For indoor use only
Operating frequency: 2405-2480 Mhz
Output power: 3 dBm
IP-class: IP44
Manufacturer: IKEA of Sweden AB
Address: Box 702 SE-343 81 Älmhult SWEDEN
The crossed-out wheeled bin symbol indicates that the item should be disposed
of separately from household waste.
The item should be handed in for recycling in accordance with local
environmental regulations for waste disposal.
By separating a marked item from household waste, you will help reduce the
volume of waste sent to incinerators or land-fill and minimize any potential
negative impact on human health and the environment. For more information,
please contact your IKEA store.
Complies with IMDA Standards DA106634
© Inter IKEA Systems B.V. 2018
AA-2159454-5
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>