KTE RT002 Ceiling Fan Remote Controller User Manual
- June 6, 2024
- KTE
Table of Contents
KTE RT002 Ceiling Fan Remote Controller
Functions of the button on the remote-control transmitter
- Lighting Power On/Off
- Increase Lighting Brightness
- Decrease Lighting Brightness
- Fan Power On/Off
- Increase Fan Speed
- Decrease Fan Speed
- LED Indicator
Attention
- When the remote-control transmitter cannot control the receiver, please check whether the batteries are installed properly or not.Also check the power level of the batteries.It may affect the control and decrease the signal transmission if the power level of the batteries is too low.
- When the transmitter cannot control the receiver, please check if there are any similar products nearby. Similar remote-control products transmit radio waves at the same time, which will cause interference.
- Replace the batteries if the power level of the battery is too low. Leakage from the battery may cause damage of the transmitter. Please dispose of used batteries properly and keep battery out of the reach of children.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE 1 : This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2 : Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>