HEQ SWAN-K1 Evtol Drone User Guide
- June 6, 2024
- HEQ
Table of Contents
HEQ SWAN-K1 Evtol Drone
Installation
Charging the Battery and Remote 
Please connect your charger with a type-C data cable to charge the remote control. Please charge the battery with the charger.
Assemble the drone
Assemble the arm
Assemble the wing
Attaching the Propellers
Open and close the remote control, Install the battery
Long press to start/shut down.
Install the battery
Remote Controller
Controlling the drone
Enter position mode
In an open outdoor environment, move the remote control to the left and wait for the aircraft to enter the position mode.
Calibrate
Please calibrate the airspeed meter and compass before flying.
How to unlock(US hand)
After entering the position mode, the throttle stick is the lowest and the heading stick is the rightmost to unlock the aircraft. After the motor rotates, please release the joystick immediately.
Take off and landing, Fixed-wing/rotor switch
Operate the aircraft in rotor mode to rise to an altitude of more than 30 meters and press the remote control A button to switch to fixed wing mode.
How to lock (US hands)
After the aircraft lands on flat ground, hit the throttle stick to the lowest position and hold it for a few seconds before the motor stops.
Disconnect the power
FCC Warning
Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Information to the user.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This Transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
This equipment complies with RF radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be operated with a minimum distance of 20cm from the
body.
IC Warning
This device complies with Industry Canada’s license-exempt RSS. Operation is
subject to the following two conditions:
- This device may not cause interference;
- This device must accept any interference, including interference that may cause undesired operation of the device.
This equipment should be operated with a minimum distance of 20cm from the body.
CE Warning
- Risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.
- The operating temperature of the device can’t exceed 40℃ and shouldn’t be lower than -15℃.
- The device complies with RF specifications when the device is used at 20cm from the body.
Hereby, Shenzhen HEQ Intelligent Technology Co. LTD. declares that this product is in compliance with essential requirements and other relevant provisions of Directive 2014/53/EU. This product is allowed to be used in all EU member states.
This content is subject to change.
Download the latest version from
http://www.hequavtech.com
Copyright©2021 HEQ All Rights Reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>