cozyflow Remote Control and Receiver Image User Manual

cozyflow Remote Control and Receiver Image User Manual

User manual

Remote Control and Receiver Image

Remote Control

Receiver

Specification

1. Product size: 105mm43mm7mm
2. Battery: CR2025
3. Working voltage: DC 2.2-3.5V
4. Quiescent current (no load): ≤5UA
5. Working current (on load): ≤25MA
6. Working frequency: 433.92±0.5MHZ
7. Working temperature: 0℃-45℃(45-85%RH)，86-106Kpa8, Storage temperature: – 25-60℃.
8. Working distance: ≥12M
9. Button height: before pressed ≤3mm, and when pressed and functioning≤0.5mm.
10. keys load life: ≥300,000 times

Pairing

Keep the remote control and receiver power on.
And then Hold and Press the center “power button” for 3 seconds to be pairing automatically.

Function

All keys codes was received by our receiver and decode to the corresponding actions by the Main driver board.

CAUTION

• Risk of explosion if the battery is replaced by an incorrect type
• disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
• leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;
• a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
• Do not ingest battery, Chemical Burn Hazard
• This product contains a button cell battery. If the button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
• Keep new and used batteries away from children.
• If the battery compartment does not close securely, stop using the product and keep it away from children.
• If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

FCC compliance statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of.

the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>