Shenzhen Hongrunfa Industrial K6 Wireless Earbuds User Manual
- June 6, 2024
- Shenzhen Hongrunfa Industrial
Table of Contents
USER MANUAL
K6 Wireless Earbuds
DIAGRAM
For charging please remove the protective film from the earphone charing
terminal.
PAIRING
Take out the earbuds, they
will enter the Bluetooth pairing mode automatically and the indicator starts
flashing green and red alternately, at this point, select “K6” on your device
to complete the pairing.
Startup & Shutdown
Note:
The earbuds will reconnect to the previously connected device by priority. If
you want to connect other smart devices, please disconnect the Bluetooth with
the previously connected device.
Power on
Power off
INCOMING CALL
VOICE ASSISTANT
MUSIC
ANC MODE
In dual mode, press and hold
the left or right earbud for 2 seconds to turn on or off the ANC mode.
CHARGING
PACKING LIST
DISPOSAL OF THIS PRODUCT
Do not put the earbuds in the charging case when the earbuds are wet.
When you see this marking or literal instruction shown on the product, it
indicates that the product should not be disposed with other household wastes
at the end of its service life. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, please dispose of this product
strictly according to the local waste disposal guidelines and separately from
other types of wastes and recycle it responsibly to promote the sustainable
reuse of material resources.
Household user should contact either the retailer where they purchased this product or their local government office, for details of where and how they can take this item for environmentally safe recycling; business users should contact their supplier and check the terms and conditions of the purchase. Please note that this product should not be mixed with other commercial wastes for disposal.
FCC STATEMEN
All changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with part 15 of the FCC rules, operation is subject to the following two conditions: (1) this device may not cause harmful interference (2) this device must accept any interference, including interference that may cause undesired operation. FCC RF Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>