RIDGE RTE 14-RTE433 Transceiver User Guide

June 6, 2024
RIDGE RTE

RIDGE RTE logo

RIDGE RTE 14-RTE433 Transceiver

what’s inbox

Make sure you have all items shown here. (Screwdriver not shown)RIDGE RTE
14-RTE433 Transceiver fig1

What’s what?

Important components labeledRIDGE RTE 14-RTE433 Transceiver
fig2

INSTALLATION

  1. Unlock and remove front panel of RTE unit; then using included carriage bolts and hex nuts, attach unit to pedestal as shown.RIDGE RTE 14-RTE433 Transceiver fig3

  2. Using Tek screws, zip ties, or included adhesive mounting pad, attach transceiver to inside wall or another surface of gate operator. CAUTION!
    The transceiver is not weatherproof and must be mounted inside a weatherproof enclosure. Internal components can be damaged if exposed to the elements.
    Failure to comply will VOID WARRANTY.
    WARNING!
    AUTOMATIC GATES CAN CAUSE SERIOUS INJURY OR DEATH!ALWAYS CHECK that the GATE PATH IS CLEAR BEFORE OPERATING!REVERSING or other SAFETY DEVICES SHOULD ALWAYS BE USED!

  3. Connect transceiverRIDGE RTE 14-RTE433 Transceiver fig5

  4. Connect transceiverRIDGE RTE 14-RTE433 Transceiver fig6

  5. .Remove transceiver cover; then hold down Programming button on circuit board for 3 seconds and let go.RIDGE RTE 14-RTE433 Transceiver fig7

  6. Remove RTE unit front panel.

  7. Hold down both Pairing Buttons until Status LED flashes. Let go of Button 2 and continue holding Button 1 only until Status LED flashes again.RIDGE RTE 14-RTE433 Transceiver fig9

  8. Relay on transceiver should click and transceiver LED should go out. Pairing is complete.RIDGE RTE 14-RTE433 Transceiver fig10

  9. Make sure gate/door path is clear; then press exit button on RTE unit and confirm gate/door opens. (If nothing happens, repeat Step 6)

  10. INSTALLATION COMPLETE! Your system is ready to use.

CHECK THAT THE GATE PATH IS CLEAR BEFORE COMPLETING THIS STEP AS IT TRIGGERS THE RELAY!

  1. The RTE unit can be disabled and re-enabled at any time by taking the key switch keys and using the key switch located below the exit button.RIDGE RTE 14-RTE433 Transceiver fig12

  2. Transceiver Reset Procedure
    This procedure is used to unpair all devices from the transceiver.

  3. Step 1 – Remove screws and remove transceiver cover.

  4. Step 2 – Press and hold Programming Button until Programming LED starts to flash. Button must be held for about 30 seconds. Once flashing stops, all devices have been unpaired from transceiver and reset is complete.

  5. Step 3 – Replace transceiver cover and secure screws.

Call 972-474-6390
Email techsupport@securitybrandsinc.com
We are available Mon–Fri / 8am–5pm Central

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals