AncSonic ASC1101 True Wireless Active Noise Cancelling Earphone User Guide
- June 6, 2024
- AncSonic
Table of Contents
AncSonic ASC1101 True Wireless Active Noise Cancelling Earphone
Packing list
Quick start guide
On/Off
Power on: The earbuds will automatically power on when the charging case is opened. Power off: The earbuds will automatically power off when they put Into the charging case and close the cover.
Bluetooth pairing
For your first time use, open the charging case and TWS will go the pairing
mode automatically.Connect your device by searching for ASCllOl.
Automatic reconnection
ASCllOl lWS will automactically reconnect to the last paired device.
Pair with other devices
The earbuds are outside the charging case, press and hold on for five seconds,
the earbuds will enter into the pairing state.
Replace the ear tips
Please replace different size ear tips for the left and right ears according
to comfort level and noise reduction effect The M size ear tips are pre-
installed on the earphones.
Touch control function
- Play/pause: right earbud or left earbud.
- Play the previous song: three clicks on the left earbud.
- Play the next song: three clicks on the right earbud.
- Answer/hang up a call: double-click your right or left ear.
- Press and hold your right or left earbud for a longer time.
- Switch mode: Press the right ear or left ear, sequentially switch toANC noise reduction mode, Normal mode, Transparent mode.
reset
- Put the earphones in the charging case and keep the cover of the charging case open;
- Press and hold the function key for 10S to restore the headset to factory settings.
Charge
- The charging box is charging: the light flashes once every ls when it is not fully charged, and stays on when fully charged.
- lnsufficient charging of the charging box: low battery, flashing3 times.
Wired charging
Charge the case with the included USB-C charging cable.
Wireless charging
Charge with a Qi wireless charging protocol compatible wireless charger when
charging, please place the charging box face up.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>