Zhejiang Uniview Technologies CB1c Smart PTZ Camera Instruction Manual

Zhejiang Uniview Technologies CB1c Smart PTZ Camera

Product appearance

Install the camera
Select a good spot for your camera Select a good spot for your camera, please install the camera in a position where its view is not blocked and ensure that It Is within _
the coverage of the Wi-Fi network.

Install the bracket
Fix the camera to a desired location. You can directly place_ t_he camera on a flat surface, or fix the bracket to the wall or ceiling by screws, and then screw the camera to the fixed base.

Set up the camera
Click the “Add Camera Now”in the App and enter the Wi-Fi network name and password that you want the camera to connect. Target the camera at the QR code of the mobile App, with a distance of
about 20cm(about 7 inches) until the camera emits a “i’.’so nd, which represents the scanning is succeeded and the pamng Is started.

Unbinding Device

If this device has been connected to otherWi-Fi or has ben bound by other users you need to unbind the device before _ rebinding. Device unbinding method: After the device is powered on and self­ checked, press and hold the reset button of the device for 5 seconds, the device will be reset and unbound.

product specification

FCC compliance statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may causeundesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure statement
  This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
  LVD/EMC Directive

Documents / Resources

| Zhejiang Uniview Technologies CB1c Smart PTZ Camera [pdf] Instruction Manual
0T1L2WT, 2AL8S0T1L2WT, CB1c Smart PTZ Camera, Smart PTZ Camera
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>