North Shore RCS-300MDX1 Commercial Door Remote User Manual
- June 6, 2024
- North Shore
Table of Contents
Thank you for choosing an RCS transmitter. It is recommended that you read this manual carefully before using the transmitter.
TRANSMITTER INTRODUCTION
1A – General Information
- The radio control, RCS-300MDX1 has been designed for the control of automatic closing systems and anti-burglar systems. The operating frequency is 300 MHz.
- The transmitter security code is obtained by means of a 10-way two-state dip-switch, which allows up to 19683 codes combinations.
- Each transmitter (or its different keys) can be stored into different receivers and hence can do more functions.
- The product fully complies with Part 15 of FCC Regulations.
1B – Technical specifications
A number of keys. 1
Battery duration: 12 – 24 months
Battery type: 23A (L1028)
Current consumption: 25 mA
Operating frequency: 300 MHz
Security code combinations number: 19683
Modulation: AM/ASK
E.r.p.: 50 – 100 uW
Range in open space: from 100 to 200 m
Operating temperature: from -10 °C to +55 °C
Dimensions: 1.75 x 1 x .3 in. Weight: .7 oz.
1D – Model Types 1 button dip-switch transmitter: Model #: RCS-300MDX1
CODING
Using a coin, insert and twist to access the battery and the dip-switches. The
dip-position will give the security code.
Warningfach transmitter is set-in-factory with the same code on the dip-
switches; it highly advisable to change this code by moving the dip-switches
to any random position ( “+”,”-“).
INFORMATION
Each dip-switch setting code has to be stored in the receiver memory. The
memorization can be done by self-learning. The instructions for this operation
are given in the receiver installation manual. Your own installer will perform
this operation during the installation or will give you the necessary
explanation during installation.
RCS-300MDX1 FCC ID: TG6RCS-300MDX1
This device complies with FCC Rules Part 15 Operation is subject to the
following two conditions:
- This device may not cause harmful interferences;
- this device must accept interference that may cause undesired operation.
Notice: any changes or modifications to RCS equipment not expressly approved by RCS could void the user’s authority to operate the equipment.
BATTERY AND DIP-SWITCH ACCESS
To access the battery, Use a coin, insert and twist. Place the 23A alkaline
battery between the 2 contacts. Respect the right polarity as indicated on the
bottom of the box.
NOTE: Please dispose of the battery correctly, they are hazardous waste.
TROUBLESHOOTING
| FAUL | SOLUTION |
|---|---|
| The radio signal is not verifiable | Replace the transmitter battery |
| The transmitter led doesn’t switch on | Replace the transmitter battery |
| The radio signal is not verifiable | Check the power supply of the receiver |
| The transmitter led switches on | Replace the transmitter battery |
GUARANTEE
The guarantee period of all RCS transmitters is 12 months, beginning from the manufacturer date. During this period, if the product does not work correctly, due to a defective component, the product will be repaired or substituted at the discretion of RCS. The guarantee does not cover the plastic container integrity. After-sale service is supplied at the producer’s factory.
REMOTE CONTROL SOLUTIONS, LLC
1-866-770-0727
www.rcsremotes.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>