Scientific Toys 5284-24GT Toys Controller Instructions

THE INSTRUCTION SHEET & PACKAGING MUST BE RETAINED SINCE IT CONTAINS IMPORTANT INFORMATION.

Try Me Unit:
Try Me button box is for demonstration purposes only. Dispose of this unit by detaching the wires connecting to the locomotive and cars before playing.
(TRY ME UNIT)

35 set contains:
Battery Loading:
(FOR MAXIMUM PERFORMANCE, USE ALKALINE BATTERIES.)
Remember to take out all batteries from the train after playing.
– Do not mix old and new batteries.
– Do not mix alkaline, standard (Carbon-Zinc), or rechargeable batteries.
– Replace with all new batteries if the train slows down or if there is sound distortion.

How to Install Battery:
FOR LOCOMOTIVE:

1. Unscrew to open the battery cover. (See Diagram 1 and 2)
2. Insert 4 x “C” batteries by matching the (+) and (–) signs as indicated in the battery compartment. (See Diagram 3)
3. Replace the battery cover. (See Diagram 4)

BOXCAR (FOR LIGHT-UP FUNCTION)
– Unscrew to open the battery cover. (See Diagram 5)
– Insert 3 x AA batteries as indicated inside following the (+)(–) polarity. (AA batteries are not included)
– Replace the battery cover and tighten the screw to secure the battery cover.

FOR HANDSET REMOTE CONTROL :

1. Unscrew to open the battery case cover at the back of the remote control and put 2 x AAA batteries inside. (See Diagram 6)
2. Close the battery case cover.

*NOTE: REMOVE ALL BATTERIES AFTER YOU HAVE FINISHED PLAYING YOUR TRAIN SET.  (ESPECIALLY FOR HANDSET REMOTE CONTROL.)

Assembly of Tracks:

1. Assemble the sections of the tracks by snapping the ends of each track section securely into another. (See Diagram 7)
2. Follow the layout of the track as shown in Diagram 8 to assemble.

FCC NOTE:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Operation of Train:

1. Make sure all wheels of the train are properly placed on the tracks following step 1, 2. (See Diagram 10)
2. Pull the train forward and backward to check the connection of the locking joints. (See Diagram 11)
3. After battery installation in remote control, the LED of the remote control will light up whenever any button is pressed.
4. Turn the bell in a clockwise direction to activate the train. (See Diagram 12) Also, the headlight will be on while the train is in “POWER ON” position.
5. Press the “FORWARD” button of remote control to start. The train will go forward. (See Diagram 13)
6. Press the “STOP” button of the remote control to make the train stop. (See Diagram 13)
7. Press the “REVERSE” button of the remote control and the train will go backward. (See Diagram 13)
8. Press the “SOUND” button of the remote control to activate the whistling sound on the train.m (See Diagram 13)
9. The train will run with the headlights on.
10. Replace the batteries if the headlight becomes dim.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

IMPORTANT
If you experience any problems or issues with this item do not take it back to the store where you purchased it. Please email service@scientific.com.hk and we will be happy to assist you in resolving any issues you may have.
We thank you for your purchase.

Additional Features:

The train can be operated without the remote control (See Diagram 14):

1. Turn the bell in a clockwise direction to activate the train (See Diagram 14)
2. Press the “Forward” button (See Diagram 14), the train will go forward only. Turn the bell in a counter-clockwise direction to switch off the train.

Hints for Better Performance:
– DO NOT run the train before reading the operating instructions.
– DO NOT operate unless all wheels are on the tracks.
– DO NOT forget to lubricate the locomotive wheels and cars after running for an extended period of time.
– DO NOT forget to keep locomotive wheels and tracks clean and free of oil and dirt.
– IF THE TRAIN FAILS TO OPERATE OR BEGINS TO SLOW DOWN:
– Replace the batteries,
– Check the positioning of batteries,
– Adjust metal contacts to assure proper contact with batteries.

Care of Locomotive, Cars, and Tracks:

1. Lubricate car wheels with a few drops of household oil.
2. After oiling, wipe the wheels with a dry cloth to remove dirt and oil, as the surface of the wheels must be clean and dry to run properly.
3. Be sure that each wheel is free of dirt.
4. Keep the track clean by wiping the rails with a dry cloth to remove any oil or dirt. This provides better traction and assures more efficient operation.

BATTERY CAUTIONS

1. For maximum performance, use alkaline batteries
2. Do not mix old and new batteries
3. Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries
4. Do not recharge a non-rechargeable battery
5. Ensure batteries are inserted with the correct polarity
6. Remove batteries when a toy is not in use
7. Remove exhausted batteries from toy and dispose of them in accordance with the maker’s recommendation
8. Rechargeable batteries should only be charged under adult supervision or by children at least 8 years old.
9. Remove rechargeable batteries from toy before charging
10. The supply terminals are not to be short-circuited
11. The antenna wires are not to be inserted into a socket outlet.

© 2022 SCIENTIFIC TOYS LTD. 1108, TOWER B,
14 SCIENCE MUSEUM ROAD, TSIMSHATSUI, HONG KONG.
PRINTED IN CHINA
O.I.NO. 6625
WARNING:
CHOKING HAZARD- Small parts. Not for children under 3 years.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>