Paul Neuhaus 14011-5 LILIA LED Ceiling Light Instruction Manual
- June 4, 2024
- Paul Neuhaus
Table of Contents
270159 – LILIA
This product contains light sources of energy efficiency class
LED
| 20 W
---|---
2.400 Im
| 43 W
2.050 Im
t
| 20.000 h
Tk
| 2.700 – 5.000 K
| 15.000 x
| <0,5s
270159
| 230V / 50Hz~
---|---
LED| 2x LED-Board 24V DC/20W
|
---|---
Directions for use
We thank you very much for choosing our product. It has been produced, tested
and packed with care and in accordance with the currently applicable European
regulations. Please unpack the contents carefully. Check immediately upon
receipt that all parts included in the scope of delivery are present and that
no damage has been caused during transport. Should there be cause for
complaint, please contact your specialist retailer.
Important notes:
- Please read these instructions carefully before assembly and commissioning. They will provide you with important information with regard to the use of the product. Please also follow the supplementary assembly instructions, if required. Keep these instructions in a safe place for your information or for ordering spare parts.
- This product is not a toy and so, it is not suitable for handling by children.
- If the product is delivered with a plug-in power supply unit, it may only be operated with this plug-in power supply unit.
- The supplied fittings, in the case of wall and ceiling luminaires, are designed for installation on a concrete ceiling or on plastered brickwork. If you have a different sub-surface for installation, please adapt the fittings so as to be suitable for that surface.
- In the case that you have purchased a the product that can be operated by a radio control system (e.g. by wireless remote control or an app), this product complies with the basic requirements of the Directive 2014/53/EU (Radio Equipment Directive) of the European Parliament and the Council of the European Union(of 16.04.2014 regarding radio equipment and the mutual recognition of their conformity). The complete Declaration of Conformity is available on the internet at the following address:
https://scm.paul-neuhaus.de/public/conformity/
Warning information:
- We, as the manufacturer, cannot be made liable for damage that is a result of improper installation or unintended use.
- The national and international electrical safety instructions must be followed for both the installation and operation.
- The electrical connection may only be made by carried out by an authorized specialist.
- It is essential that the product is de-energized during installation.
- Please ensure that the wires are not damaged during installation.
- Use only the prescribed and permitted lamps.
- Never touch halogen lamps with bare hands (use, for example, a lint-free and oil-free piece of cloth).
- The minimum distance to the surfaces that are illuminated must be maintained, without fail (see the sticker on the lamp).
- When carrying out maintenance and changing the lamp, it is essential that it has cooled down and is de-energized.
Explanation of symbols:
| Do not touch the LED!
---|---
| Protection class I: This luminaire is fitted with a protective conductor.
This must be connected to the protective conductor terminal.
| Protection class II: This luminaire has been specially insulated and may not
be connected to a protective conductor.
| Protection class III: This luminaire is intended for operation on a safety
transformer (max. 42V) and is operated with safety extra low voltage.
| Minimum distance to the illuminated surfaces (in m)!
IP44| Splash proof!
| Only suitable for use indoors!
| Use only the so-called “self-shielded” lamps!
****| Danger: Live parts can result in an electric shock.
| Do not look into the light source.
| Replaceable (LED only) light source by a professional.
| Replaceable control gear by a professional.
| Replaceable light source by an end-user.
| Replaceable (LED only) light source by an end-user.
| Replaceable control gear by an end-user.
| The luminaire can be dimmed Neuhaus 7200-16
| The luminaire can be dimmed by a remote control unit.
| The luminaire can be dimmed by a sensor.
| SimplyDim: If the luminaire is switched on again, within 3 seconds of being
switched off, the dimming process is started. The brightness with which the
luminaire is now switched off and on once again (within 3 seconds), remains
the same the next time it is switched on (memory effect).
| The luminaire can be dimmed in steps by repeatedly actuating the wall
switch.
| The luminaire can be dimmed via a touch dimmer.
| The luminaire can be dimmed via an app.
| The luminaire cannot be dimmed.
| CE confirmation by the manufacturer certifies that the product complies
with the applicable regulations and standards.
| A free-of-cost warranty is provided for all products whose packaging has the
5-year warranty seal affixed on it.
Identification of the terminals:
- PE or = green/yellow = protective conductor
- N = blue = neutral conductor
- L = black (brown) = phase
Connecting lines for table and standard lamps:
Type X If the connection line is damaged, it can be replaced by another
(available at specialist electrical stores).
Type Y In order to avoid a dangerous event, a damaged connection line may only
be replaced by a qualified electrician.
Type Z The connection line may not be replaced. If the line is damaged, the
unit must be scrapped.
Care instructions:
Maintain the value of the product through regular maintenance. Light soiling
can be removed with a damp, soft cloth. Make sure that the detergents used do
not attack the surface. Only use conventional, mild and solvent-free cleaning
agents. Never use scouring agents, acetone (nail polish remover) or chlorine-
based cleaning agents. All of the cleaning agent must then be removed from the
product without leaving any residue.
Repair: For safety reasons, the light source of this luminaire should
only be replaced by the manufacturer, a service technician commissioned by the
manufacturer or a person with comparable qualifications. If you have any
complaints, please contact your authorized retailer or make use of our Service
Hotline directly – in the case of technical queries, please specify the batch
number (xx xx xx-xx-xx-xxxxx). You can find this on the label.
+49 2922-97 21 92 90
[email protected]
Disposal instructions:
Old units must not be disposed of in household waste!
If the product can no longer be used, every consumer is legally obliged to
dispose of used appliances separately from the household waste, e.g. at a
collection point in his/her municipality or district. This ensures that old
units are disposed of properly.
If your product is battery-powered or comes with remote control, you as a
consumer are legally obliged to dispose of or return used batteries properly.
- Batteries that are not rechargeable may not be charged!
- Do not use non-similar types of batteries or new batteries along with old ones!
- Use only the recommended types of batteries or those of an equivalent type!
- Check the right polarity when inserting the batteries. Remove the batteries if the product is not to be used for a long time!
- Do not short circuit the battery contacts! This can result in excessive heating or fire!
- Do not throw batteries into the fire!
Warranty declaration: SellTec GmbH grants all users and businesses that have procured a luminaire directly from SellTec GmbH and also to all users who have procured such a luminaire from a dealer, who, in turn, has procured the luminaire directly from SellTec GmbH (authorized dealer)
- if not otherwise stated, the legal warranty for a period of 2 years
- for all luminaires that have the 5 year warranty seal affixed on the packaging, a free-of-cost manufacturer’s warranty for a period of 5 years covering the luminaire as well as the lamp, however, only if the lamp cannot be replaced and is permanently fixed to the luminaire, – the following luminaires –
The substance of the warranty:
Warranty Protection
SellTec GmbH warranties the user and/or a business that its luminaires possess
the properties that have been assured in the performance and item descriptions
and that the luminaires are free of design faults, material and manufacturing
defects. The state of the art and the scientific findings at the time of the
manufacture of the product shall be decisive. The warranty extends to the
faultless functioning of the luminaires, the built-in electronic components
and the use of faultless materials, in particular their surfaces made of
glass, metal and/or plastic.
The guarantee of the lighting function is limited by the fact that the light
output of the LED lamp decreases with its service life (wear and tear due to
use). The service life of an LED light source is defined as the period of time
in which it is in continuous operation and during which the luminosity drops
to 70% of the output value which it had at commissioning. SellTec warranties
that the LED lamps shall have, at least, the value of L70/B10. L70 means that
70% of the initial luminosity is assured after the expiry of the service life
of the LEDs. – B10 means that only 10% of the LEDs will undershoot this value
after the end of the service life of the LEDs.
Terms of the warranty
The warranty is valid under the following conditions:
- The proper use of the SellTec luminaire in accordance with its instructions for operation and use;
- Maintenance and care of the luminaire in accordance with the instructions for use;
- The mounting and installation in accordance with the instructions for operation and use and the installation instructions;
- Complying with the limit values for the supply voltage and the environmental effects in accordance with the instructions for operation and use as well as the installation instructions;
- Avoidance of chemical and physical adverse effects;
- The omission of unauthorized additions and conversions carried out on your own. What is excluded from the warranty are all items that have been procured from SellTec-lamps, which are second-choice articles or samples. A settled warranty claim does not lead to a new warranty of five years. The remaining warranty period from the original warranty period shall also apply to the replacement product.
Warranty services
In the event of a defect or deficiency in the luminaire, the warranty shall cover, at the discretion of SellTec GmbH, a free of charge repair or a free of charge replacement delivery or replacement delivery of a similar or corresponding SellTec product. SellTec GmbH reserves the right to adapt the warranty service to technical progress. Costs for assembly, disassembly and transport, as well as expenses, postage and the like are excluded from the warranty. Also consequential damages, loss of business and loss of profit, which are attributable to defective or defective SellTec products, are not covered by the assured warranty.
Warranty exclusion and warranty certificate
Warranty claims are only valid if, within the warranty period, but no later than the end of the working day following the end of the warranty period, the defective product is presented accompanied by a receipt or a dated invoice from SellTec GmbH or the authorized dealer. The corresponding purchase receipts must therefore be kept until the end of the warranty period.
Commencement of warranty
For each luminaire, whose packaging carries the 5-year warranty seal, the warranty period is 5 years. It begins on thedate of purchase, which is stated on the proof of purchase and ends 5 years after that date. In case of complaints, please contact the seller presenting the product and the sales receipt. After two years contact directly the manufacturer to find out how to proceed. An extension of the warranty is excluded. In particular, it shall not be extended by a warranty claim. Also, no new warranty begins through the provision of a replacement product. The warranty periods that are applicable to the authorized agent shall not be added on to that of the end user.
Other claims
The warranty by SellTec GmbH does not restrict the statutory rights of
consumers, in particular, the rights arising from § 437 of the BGB (German
Civil Code) (supplementary performance, withdrawal or reduction, compensation
due to damage) in the event of a defect in the luminaire, these statutory
rights exist independently of the warranty for the
luminaire. Liability under the Product Liability Act is also not limited by
the guarantee.
Enforcement of the warranty
In order to enforce the warranty, the warranty case must be reported
immediately and the product must be returned along with a copy of the proof of
purchase in accordance with Section 4 of this declaration. The notification
must be made in writing to: SellTec GmbH Olakenweg 36 59457 Werl
The defective or faulty product must also be sent to the address given above
after receipt of the return form.
SellTec GmbH
Olakenweg 36 · D-59457 Werl
+49(0)2922 9721 9290
Kundenservice@neuhaus-
group.de
www.neuhaus-group.de
Documents / Resources
| Paul
Neuhaus 14011-5 LILIA LED Ceiling
Light
[pdf] Instruction Manual
14011-5, LILIA, LED Ceiling Light, LILIA LED Ceiling Light, 14011-5 LILIA LED
Ceiling Light
---|---