FERSGO KTS Series High Performance Keyboard Tray Installation Guide

FERSGO KTS Series High Performance Keyboard Tray

Quick Installation Guide

Please check your desk before installation

Front View

Bottom View

1. The underside of my desktop is flat and free from any obstacles.
2. My desktop is at least 0.75″ thick.
3. My desktop can be driven with screws.
4. My desk is at least 27.75″ high from its underside to the floor.
5. My desk is at least 24″ wide between the legs.
6. My desk is at least 24″ deep (for KTS001 model), or 22″ deep (for KTS002 model) from the front to its back side.

Installation Guide

Step 01: Install the Track

1. Stick the 3M double-sided tapes on the track and remove the cover films.
2. Place the track under the desk and leave about 0.5″ from the edge of the desk. (Both track ends are identical.)
3. Press and hold the track for 5 seconds to allow temporary adhesion with the underside of the desk.
4. Use power drill to make the pilot holes (about 1/8″ deep), then secure it with the self-tapping screws and the bumper as the image above shows. The pilot holes will assist you in driving screws easily.

Step 2: Install the Track Guard

1. Attach the articulating arm onto the track and push it all the way back to the end of the track.
2. Place the track guard and use power drill to make pilot holes. Please make sure the center of screws align with the holes.
3. Use power drill to tighten the center screw first, followed by the rest of the screws. Please avoid over-driving as it may damage your desk and the product.

Do not over-drive the screws.
Make sure the screws align with the center of the holes.

Step 3: Install the Tray

1. Place the tray on top of the mounting plate of the articulating arm and hold it with one hand.
2. Use the hands to tighten the acorn nuts with the screws (slightly less then finger tight), it helps to fix the tray’s position temporarily.
3. You may gently adjust the tray’s position while driving the screws and make sure all the screws can be tightened properly.
4. Use a screw driver with the aid of the M5 wrench to secure all screws.

Step 4: Install the Accessories

This step is only for your reference.
You may choose whether to install the accessories upon your own preference.

Cable Clips:
Stick on the side of the tray assembly and the surface of the underside of the desk.

Adjustment

Mouse Orientation

1. Flip the tray and remove the screw at the opposite position.
2. Use the allen wrench to remove the mouse tray.
3. Swap their position and re-screw them until tightened.

Please confirm the mouse orientation before installation work begins.

Keyboard Height

1. Hold on to the both sides of the tray.
2. Gently lift the tray up and move the entire arm assembly up or down to preferred position.

Tray Tilting

1. Loose the knob handle.
2. Hold on to the both sides of the tray and tilt it to the preferred angle.
3. Fasten the knob handle.

Tray Swiveling

1. Push the side of the tray assembly to its left or right direction.
2. You can also hold on to the both side of the tray and move it to the left or right.

ANY QUESTIONS?
Please email us directly. We will answer in a day.
Email: customer_support@fersgo.com

References

• Welcome to FERSGO Ergonomics - A Better Way To Work

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>