Southern Audio Services YP-RP8R 8 Circuits Wireless Digital Switching System Instructions
- June 6, 2024
- Southern Audio Services
Table of Contents
8 Circuits Wireless Digital Switching System
Introduction
Yak Power introduces totally wireless rigging and control of your kayak! The
NEW YP-RP8R features five switched outlets, a battery-powered keypad with a
quick disconnect base and at-nut rail track mounting option, integrated RF
control, last memory mode, inline 30Afuse, and Yak Power plug-and-play
connectivity. Yak Power lets you spend less time rigging and more time
fishing.
This completely wireless Power Panel switching system is designed to make it
quick and easy for you to connect your fish finder, bait well pump, LED
lighting, phone charger, and any other 12v accessory you need out on the
water. All accessories are connected and controlled independently using
individual buttons. Each button turns RED when it is activated. And, the
Master Power switch allows you to completely power up down the entire system
to minimize your power consumption while out on the water.
Note: Make sure the plug-and-play connectors are completely pushed
together when connecting the system together. Yak-Power uses our own custom
tooled, high tolerance, very snug fitting connectors with larger gauge, real
copper wire to ensure a quality, weatherproof and reliable connection.
All our plug-and-play accessories are specifically designed to work together
while maintaining the correct battery polarity throughout the entire Yak-Power
system. Using other aftermarket connectors or splicing other connectors into
the YP system may cause damage to the system or the accessories connected to
the system and may void your warranty.
Caution: Make sure to pay attention to the actual wire colors of all our
accessory cables to ensure that the red (+) wire is always connecting to the
red (+) wire on the connector into which it is being plugged.
Features
• Integrated 8 Circuit Wireless Digital Switching System with an inline fuse.
• Last Mode Memory: The system remembers which circuits were ON when Master
Power Button is used to turn the entire system OFF. Then when the system is
turned back ON using the Master Power Button, all of the “Last Mode” circuits
will also be turned back on.
Parameter
| Power input | 12V |
|---|---|
| Circuit control | 8 ways |
| Power output | 5A@12V/CH, 30A@12V/total maximum |
| Working frequency | 2.4Ghz |
| Working temperature | -4°F -185 (-20°C-85t) |
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>