Suzhou Beisina Electronic Technology HFRMC-2100 3-Buttons Remote Control Instructions
- June 6, 2024
- Suzhou Beisina Electronic Technology
Table of Contents
Remote control instructions
Transmitter button description
Key Function
ON/OFF: used to turn on or off the fan
Speed -: Used to reduce the fan speed, short press: reduce to the minimum
speed according to a fixed ratio. Long press: reduce to the minimum speed at a
rate of 1% Speed+: Used to increase the fan speed, short press: increase to
the maximum speed according to a fixed ratio. Long press: increase to the
maximum speed at a rate of 1% Transmitting indicator: when you press any
button, it is always on the Charging indicator: the red light is always on
when charging, the green light is always on when fully charged
Speed mode: Fixed speed ratio: 10%, 15%, 20%, 25%, 50%, 75%, 100% Default
speed ratio: 25% (initial speed at startup)
Pairing method of remote control and receiver
2.1: The transmitter has a built-in battery, without any settings.
2.2.1 Remote control pairing: After the receiver is connected to the battery,
press the power switch, and the green indicator light of the receiver is
always on. Use the card pin to insert from the small hole of the shell, after
a short press, the green indicator light will turn on After the green
indicator light is off, short press any button of the transmitter. At this
time, the blue indicator light of the receiver will flash three times, and the
green indicator light will be turned on. At this time, the remote control is
successfully paired.
2.2.2 Unpairing the remote control: When the power supply of the receiver is
turned on, use the card pin to insert from the small card of the housing,
press and hold for 2S-3S, and after the orange indicator flashes three times,
cancel the currently paired transmitter.
FCC Statement
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>