tp-link RE305 AC1200 WiFi Range Extender Installation Guide
- June 6, 2024
- tp-link
Table of Contents
RE305 AC1200 WiFi Range Extender
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures: — Reorient or relocate the receiving antenna. — Increase
the separation between the equipment and receiver. — Connect the equipment
into an outlet on a circuit different
from that to which the receiver is connected. — Consult the dealer or an
experienced radio/TV technician for help. To maintain compliance with FCC’s RF
Exposure guidelines, This equipment should be installed and operated with
minimum distance between 20cm the radiator your body: Use only the supplied
antenna.
The use of the 5150 5250 MHz band is restricted to indoor use only. This
restriction will be applied in all member states.
IC Caution
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux apparei ls radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes
(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Pour maintenir la conformité aux directives d’exposition aux radiofréquences, cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.
This radio transmitter 27122-WN539N5 has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
ANT
Manufacturer
Peak
Model
Type
Gain
Frequency range
impedance
2400-2483.5MHz
Shenzhen Jiexixi
External
A
ANT A 1dBi
& 5150MHz-5250MHz
Technology Co., Ltd.
antenna
&5725MHz-5850MHz
50
2400-2483.5MHz
Shenzhen Jiexixi
External
B
ANT B 1dBi
& 5150MHz-5250MHz
Technology Co., Ltd.
antenna
&5725MHz-5850MHz
50
References
- repeater.net
- Trying to Configure the Range Extender? | TP-Link
- CE Regulatory Compliance | TP-Link
- CE | TP-Link Magyarország
- TP-Link Product Support - Wireless Networking Equipment Support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>