HCO ADAMM-RSM Wearable Device User Guide
- June 6, 2024
- HCO
Table of Contents
ADAMM-RSM Wearable Device
Quick Start Guide
How to Use ADAMM-RSM
Office: 585-471-8215 Email:
clinicaltrials@healthcareoriginals.com
1 Pleasant St, Ste 442 Rochester, NY 14604 USA
You should have:
ADAMM-RSM
Adhesive Pack
Charging Cradle
USB Wall Adapter
Quick Reference for using ADAMM-RSM
Turning ON and Turning OFF ADAMM-RSM
1. Turning ON: Press and hold 2 for 4 seconds and then release. 5 blinks blue
and then green as it powers UP.
2. Turning OFF: Press and hold 2 until the device vibrates (approximately 10
seconds) and release as soon as the device starts to vibrate. If 5 lights up
during this time, stop and repeat in one minute.
3. Reset If Not Turning ON: Press and hold 2 for 20 seconds. If 5 lights up
during this time, stop the reset, as the light means the device is now turning
ON.
Tip: A vibration will occur when you press 1 if the device is ON.
Applying the Adhesives
1. Hold the clear liner and peel the white liner away from the adhesive pad.
2. Hold the clear liner and match the adhesive shape with the device.
3. Press the adhesive pad onto the device as shown.
4. Peel the clear liner off without lifting the adhesive off the device.
Placing Device on Body
Place the ADAMM-RSMTM wearable anywhere on the upper torso (the area below the base of the neck and above the stomach on the front, side, or back). Tip: Do not slouch when sticking on the ADAMM-RSM. Tip: Figure out a few comfortable positions to wear the ADAMM-RSM and alternate wearing it in those positions from day to day.
Charging
-
Remove any adhesive from the back of the wearable.
-
Place the wearable in the charging cradle with the gold points lined up as shown.
Close the cradle and secure it with the strap. -
Make sure the cradle is connected to the wall adapter and the wall adapter is plugged
into the electrical outlet.
NOTE: Only use the provided USB Adapter.
-
The indicator light 7 will light on the wearable (it may take a few seconds). If the lights do not show, power ON the wearable. Reset if required. – Flashing RED – indicates the wearable is charging – Steady RED – indicates the wearable is fully charged
-
The device should NEVER be worn while charging.
Wi-Fi Syncing -
Press the wi-fi sync button 1 to enable Wi-Fi Sync feature on the ADAMM-RSMTM device. During this time the indicator light 4 will flash BLUE in color.
NOTE: Use Wi-Fi to upload data to cloud nightly or at least a few times a week.
QSG-B0001
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>