Zhongshan Qusun Electric QF018 Wireless Motion Sensor User Manual
- June 6, 2024
- Zhongshan Qusun Electric
Table of Contents
Zhongshan Qusun Electric QF018 Wireless Motion Sensor
Motion Sensor
The wireless motion sensor detects movement up to 12ft away. It alerts the
pager of a person’s activities when the person interrupts the motion sensor’s
infrared field, as long as the motion sensor and the pager are within 300ft
of each other. It is applicable in facilities such as bedroom, doorway, near
stairs etc.
Note : The range of wireless devices and detection distance may vary and
be dependent on your specific environmental conditions.
Product Specifications
-
Frequency: 433MHz
-
Operating Range: Up to 300ft* (in open area)
-
Range Detection Area: see Picture A*
Note : surrounding metal walls or other electronic devices might interfere or affect the signal range. Fully extend the antenna for the most optimal signal range. -
Power Supply: AA battery x 3 or 6-12V AC adaptor
Features
Easy & Simple to Use
The motion sensor detects movement and alters caregiver or staff when a person
interrupts the motions sensor’s infared field.
Flexible on Installation
The motion sensor may be mounted next to a bed to indicate when a person
arises or placed by a doorway to indicate when a person is approaching the
doorway.
Installation – Motion Sensor
If you use screws to fix the motion sensor to a permanent position, you will need to separate it and bracket before you screw the bracket to a fixture.
- Rotate the motion sensor in it’s bracket 90 degrees so that it is facing the ceiling.
- Apply gentle pressure to one arm of the bracket so that the motion sensor can easily pop out.
Mount the Motion Sensor
A. Wall Mount with Double-Sided Tape The motion sensor may be affixed to most smooth, clean surfaces with the included double sided tape. B. Wall Mount with Screws The motion sensor may be more securely mounted to walls or headboards with the included screws. Use the recessed holes for screw placement on the motion sensor.
Setup – Motion Sensor
- Insert 3 new AA batteries into the motion sensor or a 6-12V DC adaptor.
- Flip switch on front of the monitor to “ON” position.
- Test the motion sensor by waving a hand in front of the infrared sensor. If the green indicator flashes, it means the sensor is working correctly and a signal is being sent by the motion sensor.
FCC Statment
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, theuser is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>