RGBTRON DT-G6 RGB Wireless Charger User Manual
- June 6, 2024
- RGBTRON
Table of Contents
RGB Wireless Charger
USER MANUAL
Product Specification
Model No: Dt – G6
item Name: Fast Wireless Charger
Interface: Type-C
Input Voltage: 5V/9V
Input Current: 2A/1.8A
Output Power: 10W(MAX)
Dimensions: 105X105X11.55mm
Package Contents:
Wireless Charger…………………………………………… x 1 1
meter Type-C Cable (5V/2A) …………………………..x 1
User manual …………………………………………………….x 1
Product Show
How to Work
-
Connect a charger to the wireless charger. The wireless charger supports fast wireless charging.
To begin fast wireless charging, place a mobile phone that supports fast wireless charging on the wireless charger. Suggested to use QC 2.0 or QC3.0 charger (5V/2A and 9V/1.8A). -
Place a mobile phone on the charger. Check the charging icon displayed on the mobile phone’s screen for the charging status.
Indicator light identification:
| Working status | Color of light |
|---|
Connected to a power outlet, the white light will flash for 3 seconds, then
off and standby.| White+Off
Charging| White
Full charged| Off
1. Not charging properly due to a general error
2. Low power input| Flashing White
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of the device, a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.
FCC ID: 2AVI4-DT-G6
Documents / Resources
|
RGBTRON DT-G6 RGB Wireless
Charger
[pdf] User Manual
DT-G6, DTG6, 2AVI4-DT-G6, 2AVI4DTG6, DT-G6, RGB Wireless Charger
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>