XTREME LED LED High Bay Light Instruction Manual

XTREME LED LED High Bay Light

Installation Instruction

Cautions:

1. Can not use the electric generator to test the LED lamp.
2. Please abide by related country, regional and local laws and regulations when installing this fixture.
3. Please turn off the power before installation or maintenance.
4. Proper earth grounding is required to ensure safety.

Notice:

1. To avoid the possibility of electrical shock or fire, the installation personnel must have professional electric knowledge.
2. Please wear gloves to avoid injury before installation.
3. If any smoke or spark of the wire happened, please turn off the power immediately and notify relevant personnel.

Attention:

1. Please check if there is any damage during shipping. If so, please contact the manufacturer timely.
2. Please read the installation instruction carefully to check whether all the accessories are complete. After confirmation, then install the fixture according to the installation steps.

Wiring Diagram & Instruction

This led high bay light can be equipped with an optional DC motion sensor, and is available with 1-1 0V dimming function, with the following 3 dimming solutions:

1. 1-1 0V dimming,
2. Intelligent dimming with DC motion sensor,
3. Pre-install tool-free handling DC motion sensor dimming module, and choose dimming function freely.
4. According to different product models, there are two different cases that which DC12V wire and DIM wire may have three or four cores. Please refer to Figure A for the specific wiring method.

Installation Methods

Hook Mount, Ceiling Mount, 1/2″NPT Mount.(Please choose the most suitable installation method for the purchased product as per your needs).

Hook Mount:

1. Screw the hook into the fixture, lighten and fix ii. (figure 1)
2. Hang the fixture on the ceiling hook or chain. (figure 2)
3. After installation, connect the wire of the fixture to the mains according to local wiring rules, ensure the connection is stable and make good protection on the connection.

Ceiling Mount:

1. Mark with a mark pen or sharp tool on the mounting surface and drill. (figure 3)
2. Fix screws into the holes with a hammer. (figure4)
3. Align the bracket hole with screw hole (figure 5), and push the fixture to one side (figure 6) and fix ii.
4. After installation, connect the wire of the fixture to the mains according to local wiring rules, ensure the connection is stable and make good protection on the connection. By adjusting the brackets screws, users can adjust 50° to the left or right vertically. (figure 7).

1/2″NPT Mount

1. Unscrew the nuts on 1/2″ NTP. (figure 8)
2. Insert 1 /2″ NTP stem into the bracket hole. (figure 9)
3. Re-screw the nuts. (figure 10)
4. After installation, connect the wire of the fixture to the mains according to local wiring rules, ensure the connection is stable and make good protection on the connection. By adjusting the brackets screws, users can adjust 50° to the left or right vertically. (figure 11).

Installation of DC motion sensor

II could be easily installed without using any tools. Choose whether to install the motion sensor or not as per your demand (figure 12); if not, unscrew the motion sensor and replace it with a protection cover, and vice versa.
Note : the motion sensor has no dialing code, and remote control is needed for adjustment. Please refer to the instructions for remote control adjustment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>