Shenzhen Yuehai Electronic Commerce AMT-CV98LM Remote Control User Guide
- June 5, 2024
- Shenzhen Yuehai Electronic Commerce
Table of Contents
*REMOTE PI ING**
HOME BUTTON
- The distance should be in 2ft between the remote, your fire tv stick /fire tv box while you are trying to – them.
- restart the fire stick by unplugging the fire stick from the power source and plugging it back in.
- After reboot, press and hold the home button Q for 10 seconds to a minute to pair, wait until notification shows that the remote has been successfully paired on-screen, then release.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved
by the manufacturer could void your authority to operate this equipment. This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.