DREAVER MZD-02 Foot Spa Massager User Manual
- June 3, 2024
- Dreaver
Table of Contents
DREAVER MZD-02 Foot Spa Massager
INTRODUCTION
Thanks for purchasing Dreaver Foot Spa Massager. Please read the user manual carefully before use, and keep it in a safe place for future reference. Please feel free to contact our customer service if you need any support.
PACKAGE INCLUDED
- Foot spa massager x1
- User manual x1
- Remote control x1
SPECIFICATIONS
- Model MZD-02
- Name Dreaver Foot Spa Massager
- Rated Voltage 120V ~
- Rated Frequency 60Hz
- Rated Power 500W
REMOTE CONTROL PANEL
Notice:
When Pressing the TIMER, A Beep means the time is set to 20min, Double Beep
means the time is set to 60min.
PRODUCT STRUCTURE
PRODUCT OPERATION GUIDE
Open the Collapsible Foot Spa Massager
- Remove the remote control, put the foor bath flat, press the middle of the foor bath, and pull up the front.
- After pulling the front, press the middle part of the tub again, and then pull up the rear end of the foot bath.
- Lightly press the tail of the support rod, rotate the support rod, make the support rod to the supporting position.
CONNECT THE POWER CORD
Insert the power cord into the power cord socket of the folding foot bath.
ADD WATER & POWER UP
Place the machine flat, fill in a proper amount of water (it is recommended to
fill in warm
water around 35C° to reduce your waiting time) turn on the household power
supply, turn on the power foot bath.
REMOTE CONTROL
- The remote control power-on button part:
- Press the remote power-on button to turn on; press the remote power-on button again to turn off;
- In the power-on mode, the heating system works as follows: when the water temperature is > 51C°, it will enter the over-heat protection mode, at this time, it will automatically shut down,
- The remote control temperature setting part:
- Low Temp (41C°) Blue light
- Mid Temp (43C°) Yellow Light
- High Temp (45C°) Red Light
- The timing button of the remote control:
- Press one time the timer button = 20 minutes
- Press two times the timer button = 60 minutes
- The bubble function part of the remote control:
- Press the button to turn on the bubble function
WATER TEMPERATURE CONTROL
When the water temperature < the set temperature, it will reheat. When the water temperature > the set temperature, the heating will be stopped , and the water temperature will be maintained by circulating heating;
REPLACE THE CONTROL BATTERY
- Remove the battery box from the remote control and take out the original battery.
- Install the CR2025 button battery on the battery box, please pay attention to the negative and positive poles of the battery (positive electrode down). Install the battery box with the battery on the remote control.
- The remote control with a new battery.
RANGE OF REMOTE CONTROL
Within 1 meter
When using, the infrared transmitter on the remote control shall aim at the
ambient light, within a distance of one meter and at an angle of 90° to the
red light. There can be no obstruction in between.
WHEN FINISHING FOOT MASSAGE
Power off the footbath into standby mode, unplug the power supply, and pour out
the water;
Pull the support rod back by hand to move the support rod, rotate it and
install it on the panel, and then press to fold the front and back ends of the
footbath, and place the folded footbath.
Clean
- Please make sure the plug is unplugged before cleaning.
- Pour out the water from the tub.
- Wipe the surface of the foot spa with a soft cloth.
- Do not wipe the remote control and the power cord socket with a water-soaked towel.
- Do not clean the foot spa with corrosive liquids.
Store
- Cut off the power supply, unplug the power cord from the machine, and pour out the water.
- Pour out the water and place it in a safe, ventilated, dry, and cool place to drain.
- Fold the footbath, place the remote control, and fold the power cord. Put it in the packaging box, and then place it in a safe, ventilated, dry and cool place.
ATTENTION
- Please read the manual carefully before use.
- Do not pull the power cord forcefully or hang the product with the power cord to avoid damage.
- The product should be placed horizontally during use or after use.
- Do not use this product without water inside the tub. Please disconnect it from the power supply after use. Dispose of the water after unplugging the power cord.
- Do not use the product if it is damaged.
- Please stop using the product if you feel unwell (such as dizziness, headache, etc.) during the use.
- Make sure the power cord and plug are dry and away from the heat source during use.
- This product is not suitable for people with heart diseases, pregnant women, people with severe thrombosis, cerebral congestion, and advanced diabetes, and people with medical devices (such as a pacemaker), or can only be used after consulting a doctor.
- Do not stand or place a heavy object in the tub.
- Do not fill the product with hot water above 45C° directly to avoid foot scalds or product deformation.
- Do not use the product temporarily if there is inflammation, trauma or skin burns on feet.
- Do not fill the product with corrosive liquids or liquids containing particulates or floccule.
- Children, disabled (both physically and mentally), elderly people who are sluggish, and people insensitive to heat or cold should use this product under help from others.
- This product is not suitable for use within 30 minutes before and after a meal.
- The remote control and control box contains magnets, please stay away from people or things affect by magnetism.
- It is strictly forbidden to press and step on the upper cover or the edge of the upper cover in the presence of water.
- It is strictly forbidden for non-professionals to disassemble the machine.
- Do not put your feet on the edge of the basin or on the basin panel during a foot massage, so as not to cause the basin body to fold and the foot bath water to overflow.
Important
- The warranty is void in the event of damage resulting from failure to follow the instructions in this guide regarding the assembly, adjustment and maintenance of the equipment. Changes not approved by JJ-Commerce will void the JJ-Commerce product liability completely. If you have any questions, please contact our customer service department support@dreaver.nl
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>