Shen Zhen Yelaw Technology CR1002 FM and Bluetooth Clock Radio User Manual
- June 5, 2024
- Shen Zhen Yelaw Technology
Table of Contents
Shen Zhen Yelaw Technology CR1002 FM and Bluetooth Clock Radio
Chapter 1 PRODUCT DIAGRAM
Buttons
- FM& Bluetooth Mode
- Play&Scan
- Previous & Hour
- Next & Minute
- Volume Down
- Volume Up
- Dimmer & DST
- Store & Pair
- Recall & Sleep
- .Time & 12/24H
- . Set Alarm
- . Alarm ON/OFF
- .Snooze & Night Light
- Display
- Radio Antenna
- Speaker
- Type C Charging Port
- USB Charging Port
- DC IN Port
Chapter 2 OUTLET POWERED & BATTERY BACKUP
-
Pull the insulator out of the battery compartment to activate Cr2032 as a backup battery.
NOTE:
Backup battery included) doesn’t support time display, only supports backup Time &Alarm setting. -
Connect the adapter to DCjack, then plug into a 100-240V AC wall power outlet.
Chapter 3 TIME SETTING
- Press the button once, and display 2:00 starts flashing.
- .Press the HOUR button to set the hour and the button to set the minute.
- Press the button to save time or wait for another 10 seconds to 12/24H confirm automatically.
- .Hold press 12/24H button to change 12H/24H time format.
Chapter 4 ALARM SETTING ALARM
- Press SET ALM 6:00 starts flashing. button, the alarm indicator lights up, the display
- PressoUbutton to set hour, press button to set minute. HOUR
- Press ALA button to save setting or wait for another 10 seconds to confirm automatically.
- The alarm indicator Eflash. Press or HOUR select to wake up with buzzer or FM radio. ALARM
- present or wait for 10 seconds to save alarm setting.
NOTE:
If you select to wake up to FM Radio, the Radio channel you listened last time will be the default radio alarm.
In standby mode
PressVOL- button to adjust the volume alarm ring of your preference.
ALARM Press ON/OFF to turn on or turn off the most recent alarm. When the
alarm goes off
- The alarm will ring every next 9 minutes. ALARM
- Press ON/OFF to turn off the alarm for 24 hours, the alarm indicator Still be on, alarm will be activated again after 24 hours. ALARM
- To completely turn off the alarm, double pressOFFthe indicator will turn off.
Chapter 5 FM RADIO
- RepeatMDE button until the indicator get up which means FM radio is turned on.
- Manual Tuning Radio Channel Repeat HOUR or MINbutton to tune into the desired channel.
- Auto Scanning Radio Channel Press sCAN button to start auto channel scanning, radio will store the available channel to PO1, PO2, PO3.P20.
- Manual Store Radio Channel STORE Select the radio channel which you desire, press PAIR button, display will show <P+number>, such as PO5, press HOUR or to select STORE new P+number> Such as P06, then press PAIR directiy channel, the channel will be stored.
- Preset Channel Recall RECALL Press SLEEP button to switch preset channel, then pressure K orMINbutton to select the channel which you desire, such as P03 RECALLthen press SLEEP button, radio will confirm your selection.
- Adjust Radio Volume RepeatvOLor vOL button to adjust the FM radio volume.
Chapter 6 BLUETOOTH
CONNECTING & DISCONNECTING
- Repeat button until it’s in Bluetooth mode. MODE
- Once in Bluetooth mode the indicator will flash while searching for the last connected device.
- If the Last connected device is not found, the CR1002 will search for another available device.
- Select CR1002 from the Bluetooth list on your device to start pairing.
- Once pairing is successful, the indicator will stop flashing and a beep will sound for speaker.
- PressPAIR button to disconnect your device from CR1002. A beep sound PAIR to confirm the device has been disconnected successfully. CR1002 will now be in pairing mode again, allowing you to pair a new device.
PLAY OPERATION
- Repeat button to adjust the volume. or HOUR MIN
- Press button to play or pause the music. SCAN
- Press the KM button to play previous music, press button to play HOUR MIN the next music.
Chapter 7 SLEEP TIMER SETTING
In Bluetooth mode or FM mode, hold press SLEEP button to set the sleep timer, fall asleep with the radio by presetting it to play for a certain amount of time.
Chapter 8 DST SWITCH
- Hold the press the button to add an hour to the current time on the display, the indicator will light up.DIMMER
- To turn off DST, hold press DST utton again, the indicator will disappear from the display and the current time will be cut down one hour.
Chapter 9 DIMMER
Repeatedly press the button to adjust the brightness of the display to your
preference.
Chapter 10 NIGHT LIGHT
- Turn on NIGHT LIGHT Press SNOOZE / LIGHT| button then the night light will turn on.
- Turn off LIGHT LIGHT Long press the SNOOZE/ LIGHT button for 2 seconds or press it repeatedly until the night light turns off.
- Switch NIGHT LIGHT Color When the night light turns on, you can press the SNOOZE / LIGHT| button to switch to the color as you desired. The nightlight colors are as below: Oyster White, Cobalt Blue, Sky Blue, Green, Sunrise Orange, Shocking Pink, and Violet.
Chapter 11 USB CHARGING
Plug charging cable into devices such as phone or tablet. Then clock can
charge your phone or tablet. The maximum charge current is 1 Ampere.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>