CONKER NS10 10 Inch Rugged Windows Tablet User Manual

CONKER NS10 10 Inch Rugged Windows Tablet

IT’S THIS RUGGED

• IP67 Rated
• Drop Tested from 1.2 meters onto concrete
• Waterproof under a meter of water for 30 mins
• Impervious to dust
• Operating temperature between -20 °C and 60 °C
• Operating Humidity between 5% – 95%

YOUR BATTERY IS THIS GOOD

• 10,000mAh battery

YOUR NETWORK IS THIS CAPABLE

• Wifi: 802.11 a/b/g/n dual-band
• Bluetooth: 4.0 LE
• 3G or optional 4G LTE
• GPS: uBlox NEO-7 GPS
• NFC (optional): 13.56MHz
• Supports tethering
• Can cast to supported devices

THE MEMORY IS THIS BIG.

• 2GB RAM + 32GB storgage or
• 4GB RAM + 64GB storage

THE CAMERA IS THIS COOL.

• 5.0 Megapixel rear camera
• 3.0 Megapixel front camera

THE SIZE AND WEIGHT IS NO MORE THAN THIS.

• Dimensions 272 x 195 x 22 mm
• Weight 1.1kg

THE CONNECTIVITY IS THIS GOOD.

• 1 x 3.5mm Headphone jack
• 1 x USB for data (1 x OTG)
• 1 x Micro SDXC card
• 1 x Dc-in 5V
• 1 x SIM slot (micro)
• 1 x Mini HDMI
• 1 x 12-pin pogo docking connector
• Waterprood internal microphone and loudspeaker

THE PROCESSOR IS THIS FAST

• Intel Quad-Core 1.44GHz

THE DISPLAY IS BRIGHT AND STRONG

• Display 10”IPS
• Resolution 1280 x 800
• 10-point Capacitive Mulit-touch screen with
• Gorilla glass
• Brightness 300 nits

THE OPERATING SYSTEM IS

• Windows 10 Pro or LTSB

THE SENSORS CAN TELL YOU THIS MUCH.

• Accelerometer
• Gyroscope
• Compass
• Ambient light

HOW TO USE YOUR NS10 RUGGED DEVICE

1. Front camera
2. Light sensor/ notification light
3. Volume down
4. Volume up
5. Windows key
6. Power button
7. Barcode trigger
8. RJ45 Ethernet port
9. 9 pin serial port
10. Docking connector
11. Lanyard port
12. Headphones jack
13. Mini HDMI
14. Micro USB
15. Full-size USB
16. Charging Interface – DC-Input
17. Back camera
18. Barcode scanning window
19. Finger Print Scanner (optional extra)

INSTALLING SIM AND MEMORY CARD

Power off the phone before changing the SIM or Memory Card Always use the right size of SIM card

Unscrew the back cover to expose the battery as show in the diagram below

The battery is secured in place by the two sliding locks as shown above. Slide them outwards to release the battery as shown below

You have now reached the SIM and SD card slots. Insert the SIM and memory cards in the respective holders Please take care to observe the cor-rect orientation of the SIM card as per the picture below.

Now re-install the battery and make sure the sliding locks are secured in place.

When putting the back cover back on be careful not to overtighten the screws.

CHARGING YOUR TABLET

Your tablet should be charged via the DC input socket on the left edge of the device as pictured below (labeled as part 16 in the diagram on the first page of this manual). Do not charge through micro USB. Please use a 5V / 3A charger when possible. The battery in your tablet is a very high capacity and using a lower output charger will result in very slow charging.

GET IN TOUCH

To contact Conker Support:

01279 295830 Support@weareconker.com Conker Calf Pens Hatfield Park Farm Takeley CM22 6NG

Conker customers benefit from the UK’s market leader in rugged device support. Contact us with complete confidence.

Tablet Technologies hereby declares that this equipment is in compliance with Directive 2011/65/EU and 1999/5/EC or 2014/53/EU. The following standards have been applied and tested. Conformity is limited to the essenal requirements of the R&TTE.

For your safety

To reduce the potential risk of injury and or damage to equipment or property, always observe the following safety precautions.

WARNING

• Do not attempt to repair or modify the product as this could cause harm and will void any warranty.
• Do not expose your skin to the product or AC adaptor when using the product for prolonged periods.
• Do not puncture the product or battery.
• Use only the specified battery (supplied).
• Use only the specified AC adaptor (supplied).
• Ensure all port and interface covers are closed before exposing the product directly to water or elevated levels of moisture or dust.
• Packaging and accessories are choking hazards and should be kept out of reach of children.
• Do not operate the product while driving.
• Do not expose the AC Adaptor to water and do not use Adaptor when faulty.
• Prolonged use of headphones can lead to a loss of hearing.

CAUTION

• Do not operate the product if it shows any visible signs of damage.
• To prevent injury or harm, avoid looking directly at the flash or where applicable, the laser barcode scanner.
• Do not expose the product to extreme temperatures for a prolonged period. Do not expose the product directly to your skin in extreme temperature environments.

Battery

DANGER

• The battery is for use solely with the specified product. Do not use it with any other products.
• Do not use the battery if it becomes noticeably damaged or deformed.
• Do not crush, bend, deform, puncture, shred, throw, or apply high pressure to the battery.
• Only charge the battery with the supplied charger or cradle.
• Do not subject the battery to an open flame or expose it to excessive heat.
• Contents can combust under pressure.
• If the electrolyte from the battery comes into contact with the eyes, skin, or clothing, rinse thoroughly with cold water and seek medical advice.

Battery Information

CAUTION. Use only approved batteries. Risk of explosion if the battery is charged with an incompatible charger, exposed to heat

European Battery Directive 2006/66/EC
Dispose of batteries separately and responsibly. All waste batteries are classified as hazardous waste and should be disposed of at a battery recycling center.

Our rechargeable battery packs are designed and constructed to the highest standards within the industry. However, there are limitations to how long a battery can operate or be stored before needing replacement. Many factors affect the actual life cycle of a battery pack, such as heat, cold, harsh environmental conditions, and severe drops. Batteries are considered chemical products. As such, battery performance will deteriorate over me if stored for a long period of me without being used. When batteries are stored over six (6) months, some irreversible deterioration in overall battery quality may occur. Store batteries at half of the full charge in a dry, cool place, removed from the equipment to prevent loss of capacity, rusting of metallic parts and electrolyte leakage. When storing batteries for one year or longer, the charge level should be verified at least once a year and charged to half of the full charge. Replace the battery when a significant loss of run me is detected. The standard warranty period for all batteries is one year from order fulfilment, regardless if included as part of a mobile computer with a longer warranty duration or ongoing maintenance contract. The cycle life of batteries will vary according to the charge and discharge conditions, the temperature and other usage conditions. When used in accordance with the IEC charge and discharge specifications the typical cycle life of a battery is between 300 and 400 cycles at room temperature. Individual results may vary. Lithium batteries do not suffer from “battery memory” therefore you do not need to fully charge to 100% or fully discharge to 0%. Complete discharge of batteries should always be avoided. Shallow discharge is preferable, i.e. recharge at 20% if possible.

Battery Safety Guidelines

• The area in which the units are charged should be clear of debris and combustible materials or chemicals.
• Improper battery use may result in a fire, explosion, or another hazard.
• To charge the mobile device battery, the battery and charger temperatures must be between 0°C and +40°C (+32°F to +104°F).
• Do not use incompatible batteries and chargers. The use of an incompatible battery or charger may present a risk of fire, explosion, leakage, or another hazard. If you have any questions about the compatibility of a battery or a charger, contact Tablet Technologies support.
• For devices that utilize a USB port as a charging source, the device shall only be connected to products that bear the USB-IF logo or have completed the USB-IF compliance program.
• Do not disassemble or open, crush, bend or deform, puncture, or shred.
• The severe impact from dropping any battery-operated device on a hard surface could cause the battery to overheat.
• Do not short circuit a battery or allow metallic or conductive objects to contact the battery terminals.
• Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to water or other liquids, or expose to fire, explosion, or another hazard.
• Do not leave or store the equipment in or near areas that might get very hot, such as in a parked vehicle or near a radiator or other heat source.
• Do not place the battery into a microwave oven or dryer.
• Battery usage by children should be supervised.
• Please follow local regulations to promptly dispose of used rechargeable batteries.
• Do not dispose of batteries in fire.
• Seek medical advice immediately if a battery has been swallowed.
• In the event of a battery leak, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with large amounts of water and seek medical advice immediately.
• If you suspect damage to your equipment or battery, contact Tablet Technologies support to arrange for an inspection.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>