WISTOPHT WP-W22-1 Hidden Wireless Charger User Manual
- June 5, 2024
- WISTOPHT
Table of Contents
WISTOPHT WP-W22-1 Hidden Wireless Charger User Manual
Product Size Drawing
Standard Size Unit (mm)
Feature
- 1 Wireless Charger
- 1.2m Power Plug
Specification
Color Black
Wire lehgth l.2m(47.24″)
Wire diameter 3.Smm(0.14″)
Input power 9V2A
Output power SW/7.SW/l0W/lSW
Power consumption in idle ~0.3W
Chargign distance 3-Bmm(0.12″-0.31″)
Hole size <D75mm(2.95″), ~l.5-2mm(0.06″-0.08″)
away from the table
Safeguard
Material ABS
Warranty 1 year
Installation
- Tear off the 3M adhesive film on the product and insert the product into the hole at the bottom of the surface (<D75mm{2.95″), top pre-stressed leave the thickness~ l.5-2mm(0.06″-0.08″)) to make it stick.
Operation
Put the power plug in and then place the phone close to the charging label,
and the magnetic absorption function will assist the phone to move to the best
charging position.
(The magnetic absorption function only fit with the phone with magnetic
suction or the phone has magnetic case.)
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Statement
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. During the operation of device a distance
of 15 cm surrounding the device and 20 cm above the top surface of the device
must be respected. FCC ID: 2AWKM-WP-W22
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>