FIBERNET LADY Electric Motor User Manual
- June 5, 2024
- FIBERNET
Table of Contents
FIBERNET LADY Electric Motor User Manual
TECHNICAL FEATURES
- Waterproof polypropylene suitcase;
- Dimensions: 20 X 34 X 41 cm;
- 36 V – 15 Ah lithium-ion battery – Dimensions 76 X 70 X 260 mm;
- Li-Ion battery charger;
- Universal input Voltage 110/230 Vac, 50/60 Hz;
- Weight 11 Kg;
- Battery life more than 7000 meters;
- Speed controller;
- Torque controller;
ADAPTER ASSEMBLY
-
Take adapters.
-
Take your LADY jetting machine
-
Take your LADY jetting machine.
-
Insert adapters on your Jetting machine one by one.
-
Result should be as shown in picture above.
-
Put electric motor into the adapters.
-
Now you can start to jet cables.
PANEL CONTROL
- Battery Charge Level;
- Motor Electrical Consumption;
- Torque Alarm (Red Light = Torque Limiter);
- Torque Reset Button;
- Torque Control Knob;
- Protection Fuse;
- Charging Port;
- Main Switch;
- Current Alarm (Red Light = Current Limiter);
- Emergency Key;
- Speed Controller Knob;
MOTOR DIRECT CONTROL
Li-Ion BATTERY CHARGER
FEATURES
- Advanced High Frequency switching mode power supply technology;
- DC output isolated from AC input;
- Single Input 110 Vac and 230 Vac or Universal Input 110/230 Vac, 50 Hz ~ 60 Hz;
- Charging parameters are insensitive to the AC input line voltage variations;
- Completely automatic battery charging: CC, CV;
- 2 LEDs: LED 1 Red = Power on, LED 2 Red/Green = Charging/Charged;
- Short circuit, over voltage, over-temperature, reverse polarity protections;
- Efficiency > 85 %;
- Forced ventilation with fans;
- 100% full load burn-in test;
HOW TO LAY CABLES
- A. Set speed controller (11) into position “0”;
- B. Set Main Switch (8) on “I” position ;
- C. Adjust the torque using “speed controller knob”(11), according to cable outer diameter (Small cable = Low Torque / Large cable = High Torque);
IN CASE OF
- D. Torque Alarm (3) turns into red light set the speed controller (11) to “0” – Press Torque Reset Button (4) and readjust torque using its control knob (11)- (Restart from C);
- E. Current Limiter (9) turns into red light set the speed controller to “0” and switch OFF using Main Switch (8) then switch ON and restart from C;
Via degli Olmetti, 18 – 00060 Formello (RM) – Rome, ITALY
Tel. (+39) 06.90.40.50.39
Fax (+39) 06.90.40.92.66
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>