Shenzhen Homgmi Technology CTEZ102 Magnetic Wireless Car Charger User Manual
- June 5, 2024
- Shenzhen Homgmi Technology
Table of Contents
Homgmi Technology CTEZ102 Magnetic Wireless Car Charger
User Manual
This product is strong magnetic vehicle wireless charging electronic product.
The wireless charger provides up to 15W wireless charging for compatible
smartphones. It also supports EPP Qi mode. the charging power of iPhone12 and
iPhone13 series mobile phones is 7.5W, and the operating frequency of the
step-down IC MP2229 is 600kHz. The NU1509 is a highly integrated wireless
power transmitter digital controller that complies with the WPC 1.2.4 EPP
standard with a crystal oscillator operating frequency of 22.999MHz. The
NU1028 is a highly integrated full-bridge power stage IC optimized for
wireless power transmitter solutions. Working frequency: 111.0-205.0KHz.
Input: DC 5V 2A, 9V 2A, 12V 1.5A
wireless Output: 5W/7.5W/10W/15W Max
FCC Information
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
the device, a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.